VC2000Pub1000001239 7/9/04 9:19 AM Page 6
ASSEMBLING/DISASSEMBLING YOUR VACUUM CLEANER
Flexible Swivel Hose
D
E
Extension Tubes
1.To connect hose, push connector end into the opening on the front of the vacuum canister until it clicks into place
(D).
2.To remove, press the release button on the hose connector and pull out (E).
C
1.Lid release
†2. Dust filter (Part#
3.Permanent dust bag compartment
4.Permanent dust bag latch
†5. Permanent dust bag w/dust bag collar (Part#
6.Dust bag clip
†Consumer replaceable
1.To connect tubes, first connect the tube that has the storage clip. Push end closest to the clip into sweeper.
Tip: Rotate tube until storage clip faces the back side of the tube. This will make it easier to store unit.
2. Connect the other tube by pushing in one end into the
first tube and the other end into the thin end of flexible
hose (F).
Tip: You might have to twist tube slightly for a firm fit.
3. To remove extension tubes, just pull out the ends of each tube.
F
How to Use
This appliance is intended for household use. It is for indoor use only.
Important: The power cord has a yellow marking and a red marking to help you determine the maximum length to use. Up to the yellow marking is the recommended length. Never pull cord beyond the red marking.
1.Holding the power cord by the plug, pull out the required length and plug into a standard electric outlet.
G |
2.With your foot or hand, press the On/Off push button to start the vacuum cleaner (G).
5 | 6 |