Billy Goat VQ902SPH owner manual Operation, Starting

Page 10

VQ Owner’s Manual

OPERATION

Like all mechanical tools, reasonable care must be used when operating machine.

Inspect machine work area and machine before operating. Make sure that all operators of this equipment are trained in general machine use and safety.

PUT OIL IN ENGINE BEFORE STARTING

STARTING

ENGINE: See engine manufacturer’s instructions for type and amount of oil and gasoline used. Engine must be level when checking and filling oil and gasoline.

ENGINE SPEED: Controlled by throttle lever on left side of handle. Under normal conditions operate at minimum throttle to accomplish your current cleaning task. For Honda model, the stop switch is located on the switch panel on the engine

&for SP Honda models only, on remote shift control panel. NOTE: Before starting, check that all switches and fuel valves are on.

FUEL VALVE: Move fuel shutoff valve to "ON" position.

CHOKE: Located on engine. Choke engine before starting when engine is cold.

THROTTLE: Move remote throttle control to fast position. Pull starting rope to start engine.

IF YOUR UNIT FAILS TO START: See Troubleshooting on page 16.

HANDLING & TRANSPORTING:

Do not lift by hand. Use loading ramps or other mechanical assistance. Secure in place during transport. See page 3 for weight specifications

Never lift the machine while the engine is running.

STORAGE

Never store engine indoors or in enclosed poorly ventilated areas with fuel in tank, where fuel fumes may reach an open flame, spark or pilot light, as on a furnace, water heater, clothes dryer or other gas appliance.

If engine is to be unused for 30 days or more, prepare as follows:

Remove all gasoline from carburetor and fuel tank to prevent gum deposits from forming on these parts and causing possible malfunction of engine. Drain fuel outdoors, into an approved container, away from open flame. Be sure engine is cool. Do not smoke. Run engine until fuel tank is empty and engine runs out of gasoline.

NOTE: Fuel stabilizer (such as Sta-Bil) is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow mix ratio found on stabilizer container. Run engine at least 10 min. after adding stabilizer to allow it to reach the carburetor.

VACUUMING OPERATION

VACUUM NOZZLE HEIGHT ADJUSTMENT: Is adjusted by unlocking wing nut (item 32) and turning caster knob. Turning the knob clockwise increases height. Be sure the nozzle height is level (left to right) before tightening caster wing nuts.

Adjust nozzle height according to surface conditions and debris size; For vacuuming on flat surfaces, set nozzle 1/2" (12.7 mm) to 5/8" (15.8 mm) above ground; Higher for uneven terrain and turf. Note: The nozzle side bogie wheels should be at least 1/8" (3.2mm) above the ground, or maneuverability will be reduced.

FOR MAXIMUM PICKUP: Adjust nozzle close to debris, but without blocking airflow into the nozzle.

NOTE: Never bury nozzle into debris.

CLEARING A CLOGGED NOZZLE & EXHAUST: Turn engine off and wait for impeller to stop completely and disconnect spark plug wire. Wearing durable gloves, remove clog. Danger, the clog may contain sharp materials. Reconnect spark plug wire.

NOZZLE GOBBLER DOOR.

Large debris can be vacuumed without readjusting nozzle height by temporarily opening the remote Nozzle Gobbler Door. For maximum pickup of small debris, the gobbler door must be down, flush with front face of nozzle.

Part No 830542

10

Form No F0713007A

Image 10
Contents Billy Goat VQ Vacuum Contents About this ManualSerial Plate Data VQ902SPHGeneral Safety Instructions and Symbols Form No F071307A Vibration Data SoundIntended USE Instruction Labels Engine LabelsPacking Checklist PUT OIL in Engine Before StartingAssembly Tighten jam nutsOperation StartingDrive Gear selection @ 3400 RPM Maintenance Periodic MaintenanceMaintenance DriveTroubleshooting Warranty Claim ProcedureMaintenance Record Parts Drawing VQ Form No F071307A Parts List CAP TubeDescr Iptio N Switch and Wire Assembly Parts List Label Speed Control

VQ902SPH specifications

The Billy Goat VQ902SPH is a robust and versatile vacuum system designed to tackle the toughest outdoor cleanup tasks. This powerful machine is a favorite among landscape professionals and homeowners alike, thanks to its high-performance capabilities and user-friendly features.

One of the standout features of the VQ902SPH is its powerful 10.0 HP Honda engine. Known for its reliability and efficiency, this engine provides the suction strength needed to collect debris, leaves, and even small branches with ease. The vacuum boasts an impressive airflow capacity of up to 2000 CFM (cubic feet per minute), making it one of the most effective yard vacuums on the market.

The vacuum is designed with a high-dump feature that allows for easy disposal of collected debris. With a simple pull of a lever, users can dump the contents of the hopper up to 34 inches high, enabling them to empty the vacuum into trash bins or dump trucks without straining their backs. The large 37-gallon collection bag minimizes downtime by allowing for extended use between emptying.

Another notable characteristic of the Billy Goat VQ902SPH is its self-propelled system, which enhances maneuverability. Users can adjust the speed of the machine according to the terrain and their walking pace. This feature is particularly beneficial in larger yards or commercial properties where speed and efficiency are vital.

In terms of technology, the VQ902SPH incorporates a patented design that includes a unique fan system which reduces noise while maximizing suction power. This design minimizes disruption in residential areas while effectively collecting yard debris. The vacuum also features a user-friendly control panel that is easy to operate, even for those who may not be tech-savvy.

Durability is a key aspect of the VQ902SPH’s design. Constructed with heavy-duty materials, it is built to withstand the rigors of frequent use in various weather and soil conditions. The vacuum is equipped with large, pneumatic wheels that provide excellent traction and stability, allowing it to traverse different terrains without difficulty.

Overall, the Billy Goat VQ902SPH is a top-tier choice for anyone in need of a reliable yard vacuum. With its powerful engine, high-dump capability, self-propelled features, and durable construction, it is designed to make outdoor cleanup easier, faster, and more efficient. Whether you are maintaining a residential lawn or managing large commercial properties, the VQ902SPH delivers exceptional performance and convenience.