CAUTION
Reference: Label CAUTION |
|
Part No. 830138 | READ OWNER'S MANUAL |
USE PROTECTION
BEFORE OPERATING, MAKE SURE:
EXHAUST ELBOW IS ATTACHED.
EXHAUST IS DISCHARGING INTO ENCLOSED CONTAINER.
HOSE IS ATTACHED.
ALL GUARDS ARE ATTACHED. 
OPERATING INSTRUCTION IS OBTAINED.
830138
STOP ENGINE AND ALLOW T O
COOL BEFORE REFUELING.
KEEP ENGINE CLEAN OF DEBRIS.
INSPECT MACHINE BEFORE EACH USE AND REPLACE ANY
WORN AND DAMAGED PARTS.
PROPERLY SECURE EQUIPMENT BEFORE TRANSPORTING.
NEVER SERVICE UNIT WITHOUT DISCONNECTING SPARK PLUG WIRE.
USE ONLY A QUALIFIED MECHANIC TO SER VICE THIS MACHINE.
|
|
|
|
|
| ABRASIVE DEBRIS WILL SHORTEN UNIT LIFE. |
20 | TROUBLESHOOTING | Before Requesting Service Review These Suggestions | ||||
| Problem |
|
| Possible Cause |
| Solution |
Will not vacuum or has poor |
| Dirty debris bag. Nozzle height set too high or too low. Hose kit cap |
| Clean debris bag. Shake bag clean or wash. Adjust nozzle height. | ||
|
| |||||
vacuum performance. |
| missing. Clogged nozzle or exhaust. Excessive quantity of debris. |
| Check for hose kit cap. Unclog nozzle or exhaust (see page 5). | ||
|
|
|
|
|
| Allow air to feed with debris. |
|
|
|
|
| ||
Abnormal vibration. |
| Loose or out of balance impeller or loose engine. |
| Check impeller and replace if required. Check Engine. | ||
|
|
|
|
|
| |
Engine will not start. |
| Throttle in off position. Out of gasoline. Bad or old gasoline. |
| Check stop switches, throttle, and gasoline. Connect spark plug wire. | ||
| Spark Plug wire disconnected. Dirty air cleaner. |
| ||||
|
|
|
| Clean or replace air cleaner. Or contact a qualified service person. | ||
|
|
|
|
|
| |
|
|
|
|
| ||
No |
| Transmission not in gear. Operator's bail not engaging belt or out of |
| Check transmission gear selection. Check clutch cable | ||
|
|
| adjustment. Worn out or broken belt. Broken or mispositioned belt. |
| adjustment and belt and chain (See page 11). | |
|
|
|
|
|
| |
Self propelled drive will not |
| Sticking belt idler arm. | Belt fingers out of adjustment, bent or broken. |
| Check idler. Idler arm mounting screw may be too tight or too | |
release |
|
|
|
|
| loose. Check wire belt guide adjustment. Replace if broken. (see |
|
|
|
|
|
| fig. 3 & 4 adjustment on page 11). |
|
|
|
|
| ||
Noisy or broken chain |
| No chain lubrication. Chain out of alignment or over tensioned. |
| See Chain Adjustments on page 11. | ||
|
|
|
|
| ||
Engine is locked, will not |
| Debris locked inside impeller. Engine problem. |
| See page 5, Contact an engine servicing dealer for engine problems. | ||
pull over. |
|
|
|
|
| |
|
|
|
|
|
|
|
22.1
Engine Service and Warranty
WARRANTY PROCEDURE
Contact your nearest engine manufacturer's autho- rized servicing dealer.
21 | Serial Plate | Record your machine model, serial number | |
and | |||
|
|
22 Please fill in the WARRANTY CARD and send the upper part to Billy Goat. |
The WARRANTY terms are stated on the lower part which remains with the |
user. Whenever a Billy Goat Machine is faulty due to a defect in material |
and / or workmanship, the owner should make a warranty claim as follows: |
The Machine should be taken to the dealer from whom it was purchased or to an authorized Billy Goat dealer.
|
| R |
118 dB | 1803 S. Jefferson P.O. Box 308 | |
Lee's Summit, | MO 64063 / USA | |
| (816) | (816) |
| Model | |
| Unit (weight) | |
| lbs | kg |
Serial No.
Engine Power
| hp |
| kw |
|
|
|
|
The owner should present the remaining half of the Warranty Registration Card, or, if this is not available, the invoice or receipt.
The Warranty Claim will be filled in by the authorized Billy Goat Dealer, who will send it with the faulty part to Billy Goat headquarters.
The Quality / Service department at Billy Goat headquarters will study the claim and parts and will notify their conclusions.
The decision by the Quality / Service department at Billy Goat headquarters to approve or reject a Warranty claim is final and binding.
Note: To process a Warranty Claim, it is necessary to quote the Model & Serial number who are printed on the Billy Goat Serial Plate.
Purchase Purchased
Datefrom
BILLY GOAT INDUSTRIES INC.
1803 S.W. JEFFERSON STREET; LEE'S SUMMIT, MO
PHONE: | www.billygoat.com |
Part No. 800012 | Page 12 of 12 | Form No. F021402A |