Desa VF-30N-PJD installation manual Table of Contents

Page 2

TABLE OF CONTENTS

Safety Information

2

Troubleshooting

20

Product Identification

4

Wiring Diagram

23

Local Codes

5

Service Hints

24

Unpacking

5

Technical Service

24

Product Features

5

Replacement Parts

24

Air For Combustion and Ventilation

5

Specifications

25

Installation

8

Accessories

25

Operating Heater

14

Illustrated Parts Breakdown and Parts List

26

Inspecting Burners

18

Warranty Information

Back Cover

Cleaning and Maintenance

19

 

 

 

Safety Information

WARNING: Improper in- stallation, adjustment, al- teration, service or main- tenance can cause injury or property damage. Refer to this manual for correct installation and operation- al procedures. For assis- tance or additional infor- mation consult a qualified installer, service agency or the gas supplier.

WARNING: This appliance is for installation only in a solid-fuel burning mason- ry or UL127 factory-built fireplace or in a listed vent- less firebox enclosure. It is design-certified for these installations in accor- dance with ANSI Z21.11.2. Exception: Do not install this appliance in a fac- tory-built fireplace that includes instructions stat- ing it has not been tested or should not be used with unvented gas logs.

WARNING: This is an unvented gas-fired heat- er. It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. Refer to Air for Combustion and Ven- tilation section on page 5 of this manual.

This appliance may be in- stalled in an aftermarket,* permanently located, manufactured (mobile) home, where not prohib- ited by local codes.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer

www.desatech.com111826-04C

Page 1 Page 3
Image 2
Page 1 Page 3
Contents What to do if YOU Smell GAS Table of Contents Safety information Product Identification Product IdentificationUnpacking Product FeaturesLocal Codes Air For Combustion VentilationDetermining if You Have a Confined or Unconfined Space Determining fresh-air flow for heater locationConfined and Unconfined Space Ventilation Air From Outdoors Ventilation AIRVentilation Air From Inside Building Installation Check GAS TypeLOG Sizing Requirements Installation and clearances for vent-free operationMinimum Fireplace Clearance to Combustible Materials Installation Material Requirements for Distance a Safe InstallationMantel Clearances Installing Heater AssemblyDetermining Minimum Mantel Clearance When using a Hood Floor ClearancesConnecting to gas supply Installation Items NeededPropane/LP Gas Checking gas connectionsNatural Gas Operating Heater For your safety Read before lightingPressure Testing Heater Gas Connections Test Pressures Equal To or Less Than Psig 3.5 kPaFunctions Remote ControlBattery Setting The Time Shut-off ProcedureSetting The Display C/24h and F /12h Battery ReplacementManual Lighting ProcedureTo turn gas off To appliance Pilot Flame Pattern Inspecting BurnersBurner Flame Pattern Cleaning Maintenance Burner Injector HolderTroubleshooting Observed Problem Possible Cause RemedySee Cleaning and Mainte Bad module Replace module Gas leak. See WarningWiring Diagram Identifying error signals from recieverReplacement Parts Service HintsTechnical Service Parts Under WarrantyCleaning KIT GCK SpecificationsAccessories Illustrated Parts Breakdown Models VF-18N-PJD and vf-18p-pjdParts List Models VF-24N-PJD and vf-24p-pjd KEY Part Number VF-24N-PJD VF-24P-PJD Description QTY Models VF-30N-PJD and vf-30p-pjd KEY Part Number VF-30N-PJD VF-30P-PJD Description QTY Limited Warranty VENT-FREE GAS LOG Heaters Warranty InformationKeep this Warranty
Top Page Image Contents