Desa 000 to 30, 15 installation manual OWNER’S Operation and Installation Manual

Page 1

VENT-FREE PROPANE/LP GAS

RADIANT FLAME® HEATER

OWNER’S OPERATION AND INSTALLATION MANUAL

RFP30T

15,000 to 30,000 Btu/Hr

with Thermostat

Shown with

Optional Mantel featuring Built-in Base

WARNING: If the information in this manual is not followed exactly, a fire or explosion may result caus- ing property damage, personal injury, or loss of life.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

WARNING: Improper installa- tion, adjustment, alteration, ser- vice, or maintenance can cause injuryorpropertydamage. Refer to this manual for correct instal- lation and operational proce- dures. For assistance or addi- tional information consult a qualified installer, service agency, or the gas supplier.

WARNING: This is an unvented gas-fired heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate com- bustion must be provided. Re- fer to Air For Combustion and Ventilation section on page 5 of this manual.

This appliance may be installed in an aftermarket*, permanently located, manufactured (mobile) home, where not prohibited by local codes.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

* Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer

Save this manual for future reference.

Image 1
Contents What to do if YOU Smell GAS OWNER’S Operation and Installation Manual15,000 to 30,000 Btu/Hr With Thermostat VENT-FREE PROPANE/LP Heater Safety InformationProduct Identification Product FeaturesLocal Codes UnpackingInstalling Log AssemblyAssembling Heater Removing Front Panel Of HeaterProviding Adequate Ventilation AIR for Combustion and VentilationAssembling and Attaching Brass Trim Unusually Tight ConstructionDetermining FRESH-AIR Flow for Heater Location AIR for Combustion VentilationDetermining if You Have a Confined or Unconfined Space Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Installation Items Locating Heater InstallationCheck GAS Type Thermostat Sensing Bulb Installation OptionsMounting Heater to Wall Mounting Heater on Optional Hearth Base Installing Bottom Mounting ScrewsAttaching Mounting Bracket to Wall Placing Heater On Mounting BracketSee Instructions Included With Mantel Kit Assembling Mantel Securing Hearth Base to FloorMounting Heater to Optional Hearth Base External Regulator with Vent Pointing Down Connecting to GAS SupplyPressure Testing Gas Supply Piping System Pressure Testing Heater Gas ConnectionsChecking GAS Connections Operating Heater For Your Safety Read Before LightingLighting Instructions To Turn OFF GAS To ApplianceInspecting Burner Manual Lighting ProcedureThermostat Control Operation Pilot Flame PatternReplacement Parts Cleaning and MaintenanceService Hints Troubleshooting Observed Problem Possible Cause Lation requirements Gas odor even when control knob is in OFFTechnical Service SpecificationsParts Centrals Accessories RFP30T Illustrated Parts BreakdownKEY Part Number Description Parts ListModel Serial No Date Purchased Warranty Information