AquaStar 125B LPL, 125B NGL specifications Installation Checklist, Controlled Energy Corp

Page 20

INSTALLATION CHECKLIST

GAS LINE SIZE

Natural Gas

Nominal Iron Pipe Size*

1/2"

3/4"

1"

 

 

 

 

 

 

MAXIMUM LENGTH

10'

40'

150'

 

 

 

 

 

 

 

Liquid Propane

 

 

 

 

 

 

 

Semi-rigid Tubing

1/2"

5/8"

3/4"

7/8"

 

 

 

 

 

MAXIMUM LENGTH

NOT

20'

60'

150'

RECOMMENDED

 

 

 

 

* Flex tubing greatly reduces capacity and, therefore, is not recommended.

Minimum Vent Size* and Height

Minimum Diameter

Minimum Height**

 

 

5 inches

6 feet**

 

 

*NOTE: Vent size must not be restricted. Installation must comply with national fuel gas code venting requirements for a 117,000 Btu Category I appliance and any applicable local codes.

**NOTE: Minimum vent height must be 6 feet, provided there are no elbows. Termination of the vent must be 2

feet above any obstruction within a 10 foot radius of vent pipe. Consult your gas utility or National Fuel Gas Code if vent will have elbows or share venting with another appliance. The vent connector should have as much vertical rise as possible (minimum 12") before any horizontal run.

Water Pressure

For installation on well systems, insure that your water pressure is between 30 - 50 psi.

MAINTENANCE TABLE see pages 10 & 11

 

 

EVERY YEAR

EVERY 2 YEARS

EVERY 3-5 YEARS

 

 

 

 

 

 

LUBRICATE WATER VALVE

 

 

 

 

 

 

 

 

REBUILD WATER VALVE

 

 

 

 

 

 

 

 

INSPECT WATER FILTER SCREEN

 

 

 

 

 

 

 

 

INSPECT PILOT ASSEMBLY

 

 

 

 

 

 

 

 

INSPECT VENT ASSEMBLY

 

 

 

 

 

 

 

 

INSPECT MAIN BURNER

 

 

 

 

 

 

 

Replacement Parts available from North American

Distributor

CONTROLLED ENERGY CORP.

340 Mad River Park

Waitsfield, Vermont 05673

Phone 800-642-3111

Fax (802) 496-6924

www.controlledenergy.com

techsuppport@controlledenergy.com

Recycled paper

VULCANO Termodomésticos S.A.

Estrada de Cacia

3801 - 856 Aveiro - PORTUGAL

© 2001 Controlled Energy Corporation, Waitsfield, VT all rights reserved

Image 20
Contents What to do if YOU Smell GAS For Your SafetyTable of Contents Features Unpacking the Aquastar HeaterAquastar Model 125BL Open loop potable water and combination space heating system General Rules to Follow For Safe OperationCombustion AIR Requirements Proper Location for Installing Your HeaterWhere IT could Freeze Venting Mounting InstallationClearances GAS Connections and Gas Regulator To check the draftFor LP GAS GAS PIPING, Connections and Gas RegulatorGAS Line Sizing For Natural GAS Maximum Inlet GAS Flow Pressure Setting GAS Line SizingWater Connections Altitude Natural Gas Liquid PropaneFor Your Safety Read Before Lighting the Pilot Maintenance and ServiceLighting Instructions as seen on front Operating InstructionsNo gas to the AquaStar IntroductionPilot Light will not Light Pilot Lights but Flame Goes OUT When Button is Released Water is not HOT Enough Pilot Light Goes OUT During or After USEWater is TOO HOT HOT Water Temperature Fluctuates Insufficient gas pressureDiagram of AquaStar 125 BL Interior Components Diagram and Parts List Interior Components Diagram Parts List 125BL 11aPage Page Installation Checklist Controlled Energy Corp

125B NGL, 125B LPL specifications

The AquaStar 125B LPL and 125B NGL are innovative products designed to meet the growing demands of modern aquaculture and water treatment facilities. Equipped with advanced features and technologies, these models are engineered for efficiency, performance, and sustainability, making them essential tools for aquaculture professionals and facility managers alike.

One of the standout characteristics of the AquaStar 125B series is its enhanced filtration system. Both the LPL (Low Pressure Liquid) and NGL (Natural Gas Liquid) models incorporate a high-capacity filter that effectively removes particulate matter and impurities from water. This ensures higher water quality and promotes healthier aquatic life. The filtration system is designed for easy maintenance, allowing operators to perform routine cleanings without downtime.

In addition to filtration, the AquaStar 125B series boasts a state-of-the-art aeration system. Efficient oxygenation is crucial for aquatic organisms, and these models utilize fine bubble diffusers to maximize oxygen transfer rates. This technology not only ensures that fish and other aquatic species thrive but also minimizes energy consumption, ultimately reducing operational costs.

Both models feature robust, corrosion-resistant materials, enhancing their durability in challenging environments. The casing is designed to withstand exposure to wet and humid conditions, ensuring longevity and reliability in various operational scenarios. Furthermore, the AquaStar 125B series incorporates energy-efficient motors, promoting reduced power consumption and minimizing the environmental impact.

Another innovative aspect is the intelligent monitoring system integrated into both models. The digital interface provides real-time data on water quality parameters, such as pH levels, temperature, and dissolved oxygen content. This allows for proactive management and immediate adjustments when necessary, ensuring optimal conditions for aquatic life.

Safety is also a key consideration with the AquaStar 125B series. Both models feature built-in safety protocols, including automatic shutoff mechanisms and alerts for abnormal readings, further reinforcing their reliability in managing aquatic environments.

In summary, the AquaStar 125B LPL and 125B NGL represent a leap forward in aquaculture technology, combining advanced filtration, aeration systems, and smart monitoring features. Their durable design and energy efficiency make them suitable for both commercial and non-commercial applications. These models not only improve water quality but also enhance the overall productivity of aquaculture operations while being mindful of environmental sustainability.