Genie 2040L warranty Programming Remote Controls, Block the Beam While the Bullet Is Moving Down

WARNING

Be sure the carriage is disengaged from the belt before performing the following portion of the Safety-T-Beam® testing. The carriage is disengaged when the release lever is pointing down (Figure 4).

BCheck the reverse function.

•Check that the Carriage is disengaged (Figure 4).

•Press the wall button to move the bullet (Figure 5) to the open position (away from the door) (Figure 4).

–Observe the belt as it travels and adjust tension if necessary.

•Press the wall button to start the bullet in the close direction.

•Block the Safe-T-Beam® while the bullet is moving toward the door (Figure 6).

–The bullet must stop and reverse direction when the beam is blocked.

CCheck the forced closure feature (Figure 7).

•Block the Safe-T-Beam®.

•Press the wall button and verify that the bullet moves in the close direction as long as you hold the button but reverses whenever you let go of the button (Figure 7).

Figure 4 Disengage carriage

Figure 5 observe bullet travel

BLOCK THE BEAM

WHILE THE BULLET

IS MOVING DOWN.

Figure 6 Block the beam

PLACE AN OBJECT IN

THE BEAM’S PATH.

Figure 7 Block the beam

MAINTENANCE AND ADJUSTMENTS

Step 2: PROGRAMMING REMOTE CONTROLS

WARNING

A moving garage door may cause serious injury or death.

·Keep people clear of opening while door is moving.

·Do not allow children to play with Remote Controls. If the Safety Reverse does not work properly:

·Close the door and disconnect the Opener using the Emergency Release Cord.

·Do not use the door Opener, Remote Controls, or Wireless Keypad.

·Refer to the door and door Opener Owner’s Manuals before attempting any repairs.

·Stay clear of the opener's belt, the door and any other moving parts when operating the opener with a remote control.

ATo Program one Button of a Remote Control

•Locate Learn Button and Learn Indicator Light on side of Power Head (Figure 1).

Figure 1 Learn Code Button and Indicator Light

•Press and release Learn Button. Red Learn Indicator Light will blink 2 times per second.

•Press Remote Control Button once within 30

seconds(Figures 2 and 3). Red Learn Indicator Light will stay lit.

•Press Remote Control Button again. Red Learn Indicator Light will go out, indicating that memory is stored.

BProgram each additional Remote using step A above.

315 Mhz

Frequency		Frequency
		Switch
	Switch
390 Mhz
1 Button Compact Remote	3 Button Compact Remote
w/Docking Station	w/Docking Station

Figure 2 Genie Remote Controls

NOTE

Only one remote button can be entered at a time. Repeat A and B for each remote button to be programmed.

8 For Help, call 1-800-35-GENIE or visit www.geniecompany.com