Installation, How To Set The Battery | Geemarc P-AMP40 instruction

INSTALLATION

1 - HOW TO SET THE BATTERY

The P-Amp40 ampliﬁer needs with a 9V PP3 battery (not pro- vided).

To insert the battery into the ampliﬁer:

-Open the battery compartment located on the base by pressing the small plastic lock.

-Insert the 9V battery with the correct polarity into the connector in the battery compartment.

-Replace the battery cover.

-The ampliﬁer is now ready to be connected to the phone.

2 - HOW TO CONNECT THE P-Amp40 TO THE PHONE

To connect your phone to the P-Amp40 ampliﬁer:

-Unplug the handset from your telephone base socket.

-Connect the small lead supplied with the P-Amp40 to the tele-

phone base socket and to the input socket (1) located at the top of your P-Amp40 .

-Connect your handset curly cord to the output socket (2) located at the front of your P-Amp40.

-After a few seconds the battery LED will light.

IMPORTANT: If you don’t have dial tone, you will have to use the twelve position switch located on the bottom.This switch is used to match the P-Amp40 to the connections in your handset because not all telephone handset sockets have the same wiring. If you cannot hear the dial tone or the microphone does not work properly, follow the instructions below:

1. Replace the handset on the cradle and off hook again.

2.Turn the rotary switch position until get the dial tone in the earpiece.