Geemarc P-AMP40 manual Installation

Page 7
3.To test that the microphone is connected correctly, blow lightly into the mouthpiece. If you hear the ‘blowing sound’ in the earpiece, your P-Amp40 is now set. If you cannot hear the ‘blowing sound’, repeat 2 and 3 until both the earpiece and microphone are working correctly.

INSTALLATION

3.To test that the microphone is connected correctly, blow lightly into the mouthpiece. If you hear the ‘blowing sound’ in the earpiece, your P-Amp40 is now set. If you cannot hear the ‘blowing sound’, repeat 2 and 3 until both the earpiece and microphone are working correctly.

Note 1: The rotary switch is factory set in the most of common wir- ing position so always try this first before turning the switch.

Note 2: The rotary switch has deliberately been made rather stiff to avoid misoperation or accidental change of setting. We apologise if you find this inconvenient . But after first set-up, the switch will not be to turned again unless you change your phone.

Note 3: The P-Amp40 cannot be used with one-piece telephones which have a keypad on the handset. P-Amp40 is now ready to use.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Page CONTENTS button Battery LED Output socket connection TOP Tone control Volume control Boost switchDESCRIPTION DESCRIPTION BOTTOM Battery compartment Wall mount holesDESCRIPTION REAR Output socket connection1 - HOW TO SET THE BATTERY INSTALLATION2 - HOW TO CONNECT THE P-Amp40TO THE PHONE 3.To test that the microphone is connected correctly, blow lightly into the mouthpiece. If you hear the ‘blowing sound’ in the earpiece, your P-Amp40is now set. If you cannot hear the ‘blowing sound’, repeat 2 and 3 until both the earpiece and microphone are working correctly INSTALLATION6 - BATTERY INDICATOR SETTING3 - VOLUME CONTROL 5 - BOOST SWITCHIF THE AMPLIFIER DOES NOT WORK TROUBLESHOOTING1050 East Maple Rd Troy, MI GUARANTEE
Top Page Image Contents