Geemarc P-AMP40 manual Setting, Volume Control, Tone Control, Boost Switch, Battery Indicator

Page 8
SETTING

SETTING

3 - VOLUME CONTROL

You can adjust the volume control level by using the “VOLUME” control slide switch located on the top. Volume can be adjusted from the standard level of your phone up to 30 dB or more.

4 - TONE CONTROL

You can adjust the tone by using the 5 position “TONE” switch located on the top.The tone can be adjusted in 5 dB step from the 0dB mid point to the Hi or LO positions shown according to your individual requirements

5 - BOOST SWITCH

If you wish you can increase the receiving up to 10 dB more by pressing and holding the Boost switch button. During this operation the microphone is muted to avoid feedback problems. To speak release the button so that other party can hear you.

6 - BATTERY INDICATOR

The battery LED indicator should illuminate every time you use your P-Amp40. If the LED start to fade or does not light when your P- Amp40 is in use, you should change the battery to ensure optimum sound quality and performance.

IMPORTANT: Always disconnect P-Amp40 from the phone before replacing the battery.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Page CONTENTS DESCRIPTION TOP Tone control Volume control Boost switchbutton Battery LED Output socket connection BOTTOM Battery compartment Wall mount holes DESCRIPTIONREAR Output socket connection DESCRIPTION2 - HOW TO CONNECT THE P-Amp40TO THE PHONE INSTALLATION1 - HOW TO SET THE BATTERY INSTALLATION 3.To test that the microphone is connected correctly, blow lightly into the mouthpiece. If you hear the ‘blowing sound’ in the earpiece, your P-Amp40is now set. If you cannot hear the ‘blowing sound’, repeat 2 and 3 until both the earpiece and microphone are working correctlySETTING 3 - VOLUME CONTROL5 - BOOST SWITCH 6 - BATTERY INDICATORTROUBLESHOOTING IF THE AMPLIFIER DOES NOT WORKGUARANTEE 1050 East Maple Rd Troy, MI
Top Page Image Contents