Warning
Start by reading These Import Safety Instructions
Failure to comply with the following instructions may result in serious personal injury or property damage.
•Read these instructions carefully
•The garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the instructions in this manual.
These safety alert symbols mean Caution – a personal safety or property damage instruction. Read these instructions carefully.
WARNING: If your garage has no service entrance door, Model 1702E Outside Quick Release must be installed. This accessory allows manual operation of the garage door from outside in case of power failure.
Keep garage door balanced. Sticking or binding doors must be repaired. Garage doors, door springs, cables, pulleys, brackets and their hardware are under extreme tension and can cause serious personal injury. Do not attempt to loose, move or adjust them. Call for garage door service.
Do not wear rings, watches or loose clothing while installing or servicing a garage door opener.
To avoid serious personal injury from entanglement, remove all ropes connected to the garage door before installing the door opener.
Installation and wiring must be in compliance with your local building and electrical codes. Connect the power supply cord only to properly earthed mains.
Lightweight doors of fiberglass, aluminum or steel must be substantially reinforced to avoid door damage. (See page 4.) The best solution is to check with your garage door manufacturer for an opener installation reinforcement kit.
The safety reverse system test is very important. Your garage door MUST reverse on contact with a 40mm obstacle placed on the floor. Failure to properly adjust the opener may result in serious personal injury from a closing garage door. Repeat the test once a month and make any needed adjustments.
This unit should not be installed in a damp or wet space.
Door must not extend over public byway during operation.
The force, as measured on the closing edge of the door, should not exceed 400 N (40kg). If the closing force is more than 400 N, the Protector System must be installed. Do not use the force setting procedure to compensate for a binding or sticking garage door. Excessive force will interfere with the proper operation of the Safety Reverse System or damage the garage door.
Permanently fasten the caution label adjacent to the lighted door control button as a reminder of safe operating procedures.
Disengage all existing garage door locks to avoid damage to garage door.
Install the lighted door control button (or any additional push buttons) in a location where the garage door is visible, at a height of at least 1,5m and out of the reach of children. Do not allow children to operate push button(s) or remote control(s). Serious personal injury from a closing garage door may result from misuse of the opener.
Activate opener only when the door is in full view, free of obstructions and opener is properly adjusted. No one should enter or leave the garage while the door is in motion. Do not allow children to play near the door.
Use manual release only to disengage the trolley and, if possible, only when the door is closed. Do not use the red handle to pull the door open or closed.
Disconnect electric power to the garage door opener before making repairs or removing covers.
This product is provided with a power supply cord of special design which, if damaged, must be replaced by a power supply cord of the same type; such a power supply cord may be obtained from your local LiftMaster distributor and must be fitted by a specialist.
Contents | Page Illustration |
Safety Rules . . . . . . . . . . . . . . . . . . . . . . . 1
Before you Begin . . . . . . . . . . . . . . . . . . . 1
Door Types . . . . . . . . . . . . . . . . . . . . . . . . 2 . . . . . . . . . . . . . . . . 1
Tools Required . . . . . . . . . . . . . . . . . . . . . 2 . . . . . . . . . . . . . . . . 2
Hardware Provided . . . . . . . . . . . . . . . . . 2 . . . . . . . . . . . . . . . . 3
Completed Installation . . . . . . . . . . . . . . 2 . . . . . . . . . . . . . . . . 4
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . 2 . . . . . . . . . . . . .
Installation . . . . . . . . . . . . . . . . . . . . . . .
Programming your Opener & Remote . . 5 . . . . . . . . . . . . . . . 22 Program your Keyless Entry . . . . . . . . . .5 . . . . . . . . . . . . . . .23 Adjustment . . . . . . . . . . . . . . . . . . . . . . . . 6 . . . . . . . . . .
(Optional) . . . . . . . . . . . . . . . . . . . . . . . . . 7 . . . . . . . . . . . . 27 Special Features of the
Care of your Opener . . . . . . . . . . . . . . . . 9
Maintenance of your Operator . . . . . . . . 9
Operation of your Opener . . . . . . . . . . . . 9
Specifications . . . . . . . . . . . . . . . . . . . . . 10
Before You Begin
1.Look at the wall or ceiling above the garage door. The header bracket must be securely fastened to structural supports.
2.Do you have a finished ceiling in your garage? If so, a support bracket and additional fastening hardware (not supplied) may be required.
3.Depending on your door's construction, you might need a special door arm. See your dealer.
4.Do you have an access door in addition to the garage door? If not, Model 1702E Outside Quick Release Accessory is required.
1