Install the Protector System, Accessories

27Install the Protector System™

(See accessories)

The force, as measured on the closing edge of the door, should not exceed 400 N (40kg). If the closing force is adjusted to more than 400 N, the Protector System must be installed.

After opener has been installed and adjusted, The Protector System™ accessory can be installed. Instructions are included with this accessory.

The Protector System™ provides an additional measure of safety against a small child being caught under a garage door.

It uses an invisible beam which, when broken by an obstruction, causes a closing door to open and prevents an open door from closing and is strongly recommended for homeowners with young children.

28Special Features

A.Door within a door connection Disconnect opener from power!

Remove cover. Locate auxiliary terminal block (TB1) on the control board. Remove jumper from terminal leads 1 and 2 (not shown). Replace with contact switch leads as shown.

B.Flashing light connection

The flashing light can be installed anywhere. Connect light leads to terminals 3 and 4 on the terminal block.

C.Coaxial antenna adapter

A coaxial antenna connection can be used if the transmitter range is too short. Cut off the existing antenna. Use standard coax cable and connector. Strip off end of insulation to “X” dimension.

433 MHz: X = 250mm. Reposition antenna.

29Accessories

(1)Model 94330E Single-Function Remote Control

(2)Model 94333E 3-Function Remote Control

(3)Model 94335E 3-Function Mini Remote Control

(4)Model 94334E 4-Function Mini Remote Control

(5)Model 975EML Laser Garage Parking Assist

(6)Model 128LM 2-Function Wireless Wall Control

(7)Model 9747E Keyless Entry System

(8) Model 78LM	Multi-Function Door Control Panel
(9) Model 760E	Outside Keylock
(10) Model 1702E	Outside Quick Release
(11) Model 770E	The Protector System™
(12) Model 1703E	The Chamberlain Arm™
(13) Model FLA230	Flashing Light Kit
(14) Model 16200LM	Pedestrian Door Switch
(15) Model MDL100LM	Mechanical Door Latch Kit
(16) Model EQL01	Door Handle Quick Release - 2.5m
Model EQL02	Door Handle Quick Release - 4.0m

(17)Model 100027 1-Position Key Switch (Flush Mount - 100010)

Model 100041 2-Position Key Switch (Flush Mount - 100034)

WIRING INSTRUCTIONS FOR ACCESSORIES

Keyless Entry System – To opener terminals: Red-1 and White-2

Outside Keylock – To opener terminals: Red-1 and White-2

Protector System™ – To opener terminals: White-2 and Black-3

Door Control Panel – To opener terminals: Red-1 and White-2

3031 Replacement Parts

7-en