Program your Opener & Remote | Chamberlain 5580A-2GB instruction

22Program your Opener & Remote

Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door.

Your garage door opener receiver and remote control transmitter are set to a matching code. If you purchase additional remote controls, the garage door opener must be programmed to accept the new remote code.

Program the Receiver to Match Additional Remote Control Codes:

Using the “LEARN” Button

1.Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds (1).

2.Within 30 seconds, press and hold the button on the hand-held remote that you wish to operate your garage door (2).

3.Release the button when the motor unit light blinks. It has learned the code. If light bulb is not installed, two clicks will be heard (3).

Using the Multi-Function Door Control (optional):

1.Press and hold the button on the hand-held remote that you wish to operate your garage door (4).

2.While holding the remote button, press and hold the LIGHT button on the Multi-Function Door Control (5).

3.Continue holding both buttons while you press the push bar on the Multi-Function Door Control (all three buttons are held) (6).

4.Release buttons when the motor unit light blinks. It has learned the code. If light bulb is not installed, two clicks will be heard (7).

Now the opener will operate when the remote control push button is pressed. If you release the remote control push button before the opener lights flash, the opener has not learned the code.

To Erase all Remote Control Codes

To deactivate any unwanted remote, first erase all codes:

Press and hold the “learn” button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

3-Channel Remote:

If provided with your garage door opener, the large button is factory programmed to operate it. Additional buttons on any rolling code

3-channel remote or mini-remote can be programmed to operate other rolling code garage door openers or gates.

23Program your Keyless Entry (optional)

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.

Program the Receiver to Match Additional Remote Control Code Using the orange “LEARN” Button:

1.Press and release the orange “learn” button (1) on opener. The learn indicator light will glow steadily for 30 seconds.

2.Within 30 seconds, enter a four digit personal identification number (PIN) of your choice on the keypad (2), then press and hold the ENTER button.

3.Release the button when the opener light blinks (3). It has learned the code. If light bulb is not installed, two clicks will be heard.

NOTE: This method requires two people if the Keyless Entry is already mounted outside the garage.

Using the Multi-Function Door Control (optional):

1.Enter a four digit personal identification number (PIN) of your choice on the keypad, then press and hold ENTER (4).

2.While holding the ENTER button, press and hold the LIGHT button on the Multi-Function Door Control (5).

3.Continue holding the ENTER and LIGHT buttons while you press the push bar on the Multi-Function Door Control (all three buttons are held) (6).

4.Release buttons when the opener light blinks. It has learned the code. If light bulb is not installed, two clicks will be heard (7).

5-en