REMOTE CONTROL (CONTINUED)ANTENNA CONNECTIONS

BATTERY INSTALLATION

HSlide the pattery compart-
ment cover inthe direction
ofthe arrow. Install two =AA"(penlightsize) batteries, paying
attention to the poladty
diagram in the battery compartmenL
Replace the compadment
cover,

BATTERY PRECAUTIONS

r
Theprecautions below should befollowed when using batteries inthis device:
1. Use onlythe size andtype ofbatteries specified,
2. Be sure to follow the correctpufadty when installing the batteries as indicated in the batterycomparirnent.
Reversed bederies maycause damage to the device.
3. Do not mixdifferent types ofbattebes together (e.g. Alkalineand Carbon-zinc) or old pettebes with fresh
ones,
4, Ifthe device is not to be used for along period of time, remove the baifer;es to prevent damageor injury
frompossible battery leakage.
5. Do not try to recharge batteriesnot intended to be recharged; they can overheat and rupture. (Folk_w
battery manufacturer's directions.)

EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER

•0
NOTE: • When them is an obstacle between the TVNCR and the transmitter, the transmitter may notoperate.
• When directsunlight, an incandescentlamp, fluorescentlamp orany other stronglight shines onthe
Remotesensor ofthe TV/VCR, the remote operation may be unstable.
Ifyou are using outdoor antenna (outdoor antenna not included), follow the instructions below that
commpond to your antenna system, If you are using a cable TV service (CAW), see page 13 for Cable
"IVconnections.

Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire)

Connect the 75 ohm cable from the combination VHF/
IUHF antenna to the antenna jack.
Ifyour combinationVHF/UHF antenna has a300 ohm
_A_IONHGM_ twin-lead wire,the use of the 300-75 ohmmatching
transformermay be necessary,
75OHM
COAXIAL
CABLE
TRANSFORMER
(notincluded)

Combination VHF/UHF Antenna (Separate VHF and UHF 300 ohm twin-lead wires)

•Connect the UHF 300 ohmtwin-lead wire to the
OHM
MATCHING
TRANSFORMER
(not included)
VHF 300 ohm
COMBINER
(notincluded) UHF 300 ohm
combiner (not supp4ied),Connect the VHF 300 ohm
twin-lead wire to the 300-75 ohm matching trans-
former,Attach thetransformer to the combiner, then
attachthe combiner tothe antenna jack.

Separate VHF/UHF Antennas (75 ohm VHF cable and 300 ohm UHF twin-lead wires)

Connect theVHF 75 ohm e_,bleand UHF 300 ohm
twin-lead wire tothe combiner. Attachthe combiner
COMBINER tothe antennajack.
(notincluded)
10 11