Hitachi 210313 manual Fire and Explosion Hazard

Page 4

WARNING

FIRE AND EXPLOSION HAZARD

Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and re- sult in a fire or explosion and serious injury.

DGround the equipment and the object being sprayed. Refer to Grounding on page 5.

DIf there is any static sparking or you feel an electric shock while using this equipment, stop spray- ing/dispensing immediately. Do not use the equipment until you identify and correct the problem.

DProvide fresh air ventilation to avoid the buildup of flammable fumes from solvents or the fluid being sprayed/dispensed.

DKeep the spray/dispense area free of debris, including solvent, rags, and gasoline.

DBefore operating this equipment, electrically disconnect all equipment in the spray/dispense area.

DBefore operating this equipment, extinguish all open flames or pilot lights in the spray/dispense area.

DDo not smoke in the spray/dispense area.

DDo not turn on or off any light switch in the spray/dispense area while spraying/dispensing or while operating if fumes are present.

DDo not operate a gasoline engine in the spray/dispense area.

TOXIC FLUID HAZARD

Hazardous fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin, inhaled, or swallowed.

DKnow the specific hazards of the fluid you are using.

DStore hazardous fluid in an approved container. Dispose of hazardous fluid according to all local, state and national guidelines.

DAlways wear protective eyewear, gloves, clothing and respirator as recommended by the fluid and solvent manufacturer.

4307160

Image 4 Contents
Instructions Parts List Model 210313, Series DTable of Contents SymbolsInjection Hazard Fire and Explosion Hazard Installation General Information GroundingFilters Hydraulic LinesDrip Pan Drain ValveKEY Operation Pressure Relief ProcedureFlushing the Pump Starting and Adjusting the Pump Check Valve AdjustmentCorrosion Protection MaintenanceShutdown Troubleshooting Problem Cause SolutionService Disassembly See FigParts Description QtyDimensions Mounting Hole Layout Npt outlet Npt inlet 48.1 1220 mm 23.2 585 mmTechnical Data Pump Performance ChartsPump Pressure Developed Pump OutputGraco Standard Warranty Graco Information