CHANGING BRUSHES
To replace brushes carry out the following sequence of operations:
The machine should be switched on but all functions switched off.
Raise the brush unit by pressing down the brush lift/lower pedal and latching in its lowest position.
Press the brush release push button momentarily and the brushes at present fitted will be unloaded from the machine.
Move the machine backward by rolling the traction control rearward until the brushes are visible in front of the machine.
16
PREPARATION FOR USE
Lower the brush unit by pushing the pedal to the right to unlatch it. Then allow it to rise as far as it will go. Push the machine forward then back about 50mm (2”) to ensure the drive has located in the brushes.
Press the brush “on/off” push button: the indicator will light and the brush motors will engage the brushes.
Once the brushes have locked on, raise the brush unit by pushing the pedal down and latching it at its lower position.
Press the brush “on/off” push button again (see previous picture); the green indicator will wait for the motors to spin down to stop before going out.
Note: The motors do not stop immediately.
The brushes are now loaded onto the machine.
9