INSTALLATION
STEP 5: INSTALL THE MOUNTING PLATE
THE OVEN MUST BE CONNECTED TO AT LEAST ONE WALL STUD.
1.Draw a vertical line on the wall at the center of the 30″ wide space.
Use the mounting plate as the template for the rear wall. Place the mounting plate on the wall, making sure that the tabs are against the bottom of the cabinet. Line up the notch and center line on the mounting plate to the center line on the wall.
2.While holding the mounting plate with one hand, draw circles on the wall at holes A, B, C and D. Four holes must be used for mounting. If the holes are not used, the installation will not be secure. Installer must use these holes for proper installation. Use toggle bolts through these holes unless one of them lines up with a stud. Use a wood screw for studs.
NOTE: Draw a fifth circle inside area E, through one of the bottom holes to match the location of a stud.
For
3. Drill holes on the circles. If there is a stud, drill a 3 / 16″ |
hole for lag screws. If there is no stud, drill a |
3 / 4″ hole for toggle bolts. Make sure to use at least 1 lag |
screw in a stud, and 4 toggle bolts in the drywall or the |
plaster. |
4. Attach the plate to the wall. To use spring toggle heads |
bolts: Remove the toggle wings from the bolts. Insert the |
bolts into the mounting plate and replace the spring toggle |
heads to 3 / 4″ past the bolt ends. Insert the spring toggle |
heads into the holes in the wall to mount the bracket. You |
may pull forward on the bracket to help in tightening the |
3/16" Hole on Studs 3/4" Hole on Drywall Only
Minimum 66"
From the Floor
For Wall-
Vented Only
| Draw Lines |
Mounting | on Studs |
| |
Plate | Draw |
| Center Line |
A | B |
C | Center Line | D |
|
| |
|
| E |
Support Tab | Support Tab | |
Figure 26
toggle bolts. Tighten all bolts. |
Mounting
Space More Than Wall Thickness
Toggle Wings
Plate | Toggle Bolt |
Bolt
End
Wall
Figure 27
18
