INSTALLATION
STEP 6: ATTACH THE OVEN TO THE WALL
6. Roof vented installation:See Figure 33
Install ductwork through the vent opening in the upper cabinet. Complete the venting system through the roof according to the method needed. See “PREPARE THE VENTING SYSTEM,” STEP 2 on the page 8. Use caulking to seal exterior roof opening around the exhaust cap. See Figure 6 on page 8.
7.Use power supply cord clamp to bundle the power supply cord. Install the power supply cord clamp, using a screw as shown in Figure 34, to inside of the cabinet.
8.To install the grease filter: Slide it into the slide slot, then push up and toward oven center to lock.
See Figure 35.
9.Plug in the power supply cord.
10.Read your Owner’s Manual, then check the operation of your microwave oven.
damper |
Figure 33
duct |
power |
supply |
cord |
clamp |
Figure 34
Figure 35
21
