INSTALLATION
STEP 5: INSTALL THE MOUNTING PLATE
TO PREPARE THE REAR WALL CUTOUT OPENING AND EXHAUST ADAPTOR/MOUNTING PLATE FOR WALL- VENTED:
F | G |
H | I |
1.Place the mounting plate against the rear wall as described in step 5 item 1 (page 14).
2.Using a pencil, put dots through slots F and G, and through holes H and I. Remove the mounting plate and draw lines extending through the points. This will give the location and size of the box cutout for the rear wall duct.
• Attach the exhaust adaptor to the rear mounting plate by |
sliding it into the guides at the top center of the plate on |
the wall side. Push in securely until it is past the top |
locking tabs and in the lower locking tabs. Take care to |
assure the damper hinge is installed so that it is at the top |
and that the damper swings freely. |
• Carefully guide the exhaust adaptor, now attached to the |
mounting plate, into the house duct, before using the |
screws to attach the plate to the wall. This will assure |
proper alignment for installation. |
• Return to step 5, item 3 (page 14) to continue. After |
completing the installation of the mounting plate, again |
Exhaust Adaptor
Slide exhaust adaptor into guides on rear panel.
Figure 28
Damper (hinge side up)
Mounting Plate (wall side)
Locking
Tabs Guides
check the rear damper for free movement to assure it will |
operate properly. |
Figure 29
19