Electrolux W 365 B, W 375 B, W 345 B/M, W 355 B/M manual Travel Direction Floor Level

Page 13

SCRUBBING AND DRYING OPERATION

SCRUBBING AND DRYING OPERATION

Push the machine slowly forward, and adjust the squeegee pressure control until the lips bend over evenly as illustrated below. Then re-adjust the rake control to make the radius of the squeegee sit parallel to the floor and the lips bend evenly.

TRAVEL DIRECTION

FLOOR LEVEL

The lips must be replaced when they become feather edged or torn.

Fully lift the squeegee control lever (just below and to the right of the machine handle) to lower the squeegee to a flat floor surface.

If the recovery tank full indicator lights continuosly for a period of 6 seconds the suction motor will switch off and the tank will have to be emptied before continuing the operation.

Note:

Lift the brushes whilst still moving forward then stop traction, in that order, to avoid “polo rings”. Lift the squeegee and stop the suction motor. Drive the machine to an emptying point or use a transfer trolly to empty the recovery tank.

14

Press the brush “on/off” push button: the indicator will light and the brush motors will start.

Lower the brush unit by pushing the pedal to the right to unlatch it.

Drive the machine forward by holding the hand- grips. And turning the thumb wheels.

11

Image 13
Contents Manual for USE and Maintenance Index Introduction OptionalsUnpacking Optionals Models Technical SpecificationMachine Controls Trouble ShootingPreparation for USE Safety and FaultsPreparation for USE Maintenance 345-355 Maintenance Preparation for USEPreparation for USE Changing Brushes Brushes are now loaded onto the machine Scrubbing and Drying Operation OFFTravel Direction Floor Level Scrubbing and Drying Operation