Harman-Kardon AVR 3600 owner manual AM and FM Antenna Terminals Connect the included

Page 11

REAR-PANEL CONNECTIONS

Component Video Monitor Outputs: If you are using one of the Component Video Inputs and your television or video display is component-video-capable (but does not have an HDMI input), connect these jacks to the video display.

NOTES:

•Due to copy-protection restrictions, there is no output at the Component Video Monitor Outputs for copy-protected sources.

•Composite video signals are upscaled to as high as 1080i and available at these outputs. If your video display’s best connection is component video, it is the only video connec- tion required from the AVR to the display.

AM and FM Antenna Terminals: Connect the included

AM and FM antennas to their respective terminals for radio reception.

Preamp Outputs: Connect these jacks to an external amplifier if more power is desired. The Surround Back/Zone 2 Preamp Outputs may be used with an external amplifier to power the remote zone of a multizone system.

A-BUS Port: Use a Category 5/5e cable to connect this port to optional A-BUS equipment for multizone operation. When the A-BUS system is used, it is possible to have a full 7.1-channel system in the main listening room at the same time the multizone system is in use.

Front, Center and Surround Speaker Outputs:

Use two-conductor speaker wire to connect each set of terminals to the correct speaker. Remember to observe the correct polarity (positive and negative connections).

Surround Back/Zone 2 Speaker Outputs: These speaker outputs are used for the surround back channels in a

7.1-channel home theater, or may be reassigned to a remote room for multizone operation.

Switched AC Accessory Outlet: You may plug the AC power cord of one source device into this outlet, and it will turn on whenever you turn on the receiver. Do not use a source that consumes more than 50 watts of power.

AC Power Input: After you have made all other connections, plug the AC power cord into this receptacle and into an unswitched wall outlet.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents AVR Wet Location Marking Safety InformationImportant Safety Instructions Service Instructions Outdoor Use MarkingUnpacking Important Safety InformationFPO Table of ContentsSurround Modes IntroductionDigital Audio Inputs Supplied AccessoriesAudio Inputs Audio/Video InputsControls FrontPanel FRONT-PANEL Controls On When the AVR is turned on, this LED turns whiteVolume Knob Turn this knob to raise or lower the volume Connections RearAlways make a separate audio connection REAR-PANEL ConnectionsUse an HDMI-to-DVI adapter AM and FM Antenna Terminals Connect the included Main Remote Control Functions Surround Modes Press to directly access the Surround AVR Power Off Button Press to turn off the AVRMain Remote Control Functions Menu Navigation Zone 2 Remote Control FunctionsIR Transmitter Mute Source Selectors Sleep Settings Zone 2 Remote Control Functions Harman International the Harman Kardon parent company Logic Introduction to Home TheaterTypical Home Theater System Multichannel AudioAudio Connections Connecting Source Devices to the AVRSpeaker Connections SubwooferAnalog Video Video ConnectionsAnalog Audio Digital VideoUSB Port AntennasSubwoofer Placement Speaker PlacementFront Speaker Placement Placement of Surround Speakers in a 5.1-Channel SystemGame Media Server Getting StartedSource Assignment Worksheet Getting Started Installation Step Eleven Insert Batteries in Remote Step Nine Install a Multizone SystemStep TEN Plug in AC Power Cords Connect IR Control Devices to the Zone 2 IR InputTwo steps are required the first time you turn on the AVR Step Twelve Program Sources Into the RemoteLearning Step Thirteen Turn On the AVRInstallation Configure the AVR 3600, Using EzSet/EQ Technology Initial SetupUsing the ON-SCREEN Menu System Established by the EzSet/EQ process Set Up SourcesAudio and Video Input Selection Channel Inputs You are now ready to begin enjoying your new receiver Operation Volume ControlDolby Volume Dolby Volume Calibration OffsetMute Function Sleep TimerHeadphones Using the RadioRecording Sirius Satellite Radio OperationPrevious Track Using Docking StationUsing The Bridge Remote Control KeyPlay Pause Menu Back/Exit or Left Arrow Select IPod Manual ModeSelecting a Surround Mode Operation Audio Processing and Surround Sound Analog Audio SignalsDigital Audio Signals Advanced FunctionsVideo Game Logic 7 Game Dolby Surround SettingsManual Speaker Setup Number of Speakers Step Three Manual Setup MenuStep ONE Determine Speaker Crossover Step TWO Measure Speaker DistancesSub Mode Adjust Crossover Frequencies MenuAdjust Speaker Distance Menu Video Adjustments Step Four Setting Channel Output Levels ManuallyVideo Modes Menu Video ModesHow to Adjust the Custom Picture Settings General AVR Settings System SettingsPunch-Through Programming Advanced Remote Control FunctionsMenu Appearance System InformationTo program, or record an activity, follow these steps Resetting the RemoteProcessor Reset MemorySymtom Cause Solution Troubleshooting GuideTable A1 Recommended Source Component Connections Table A2 Source Setting DefaultsAppendix Analog Audio Inputs Table A3 Speaker/Channel Setting DefaultsTable A4 Delay Setting Defaults All Digital and 2-Channel Your SettingsBridge Table A5 Source SettingsTable A6 Audio Effects Settings DefaultAuto Select Table A7 Video Modes SettingsBlack Level Off Deinterlacing Film Mode Detect Table A8 Surround ModesTable A11 Zone 2 Settings Table A9 Remote Control CodesTable A10 System Settings Table A12 Surround Modes Surround Mode Description Incoming Bitstream or SignalTable A12 Channel music recordings DTS StereoPresentation DTS Neo6 DTS 2/2/.0 or .1, 3/2/.0 or41 42 Radio Table A13 Remote Control Function ListAUX Table A13Table A14 Remote Control Product Codes TV Table A16 Table A15 Remote Control Product Codes AUX-HDTVTable A16 Remote Control Product Codes AUX-VCR Table A14Table A17 Table A17 Remote Control Product Codes AUX-CDTable A18 Remote Control Product Codes DVD Table A21 Remote Control Product Codes Cable Table A19 Remote Control Product Codes SATTable A20 Remote Control Product Codes Game Table A21 Table A22 Remote Control Product Codes AUX-MEDIA ServerTable A24 Remote Control Product Codes AUX- TiVo Audio Section AVR 3600 Technical Specifications

AVR 3600 specifications

The Harman-Kardon AVR 3600 is a high-performance audio/video receiver that brings exceptional sound quality and advanced features to home entertainment systems. Known for its sleek design and powerful performance, the AVR 3600 is engineered to deliver an immersive audio experience that meets the needs of both casual listeners and serious audiophiles.

One of the standout features of the AVR 3600 is its multi-channel audio capabilities, supporting the latest surround sound formats such as Dolby Atmos and DTS:X. This enables users to enjoy a three-dimensional audio experience, where sounds can be precisely placed and moved around in space, enhancing the realism of movies, music, and games. With a robust amplifier section, the AVR 3600 offers impressive power output, ensuring that even the most dynamic content can be enjoyed to its fullest.

Another significant characteristic of the AVR 3600 is its extensive connectivity options. The receiver is equipped with multiple HDMI inputs, allowing for seamless integration with various devices such as Blu-ray players, gaming consoles, and streaming devices. The HDMI inputs support 4K Ultra HD video passthrough, as well as HDR10 and Dolby Vision for stunning visuals. Additionally, the AVR 3600 includes legacy connections, such as optical and coaxial inputs, making it versatile for older equipment.

The AVR 3600 also features advanced calibration technologies, allowing users to optimize the sound for their specific room layout. The built-in Auto Calibration technology analyzes the acoustics of the space and adjusts settings accordingly, ensuring optimal performance. This feature is particularly beneficial for users who may not have the expertise to manually adjust settings.

For those who value easy control and management of their entertainment systems, the AVR 3600 is compatible with various smart home technologies. It supports wireless connectivity through built-in Wi-Fi and Bluetooth, enabling users to stream their favorite music from mobile devices effortlessly. The user interface, accessible via the receiver’s on-screen menu, is intuitive, allowing for easy navigation and control.

In summary, the Harman-Kardon AVR 3600 combines advanced audio technologies, versatile connectivity, and user-friendly features, making it an excellent choice for anyone looking to elevate their home theater experience. With its powerful audio performance and modern capabilities, the AVR 3600 stands as a strong contender in the competitive AVR market.
Top Page Image Contents