Bissell 25A3, 64D9 warranty Carpet cleaning, Handle Release

Operation

Carpet cleaning

1.Plug the deep cleaner into a proper outlet. Set ReadyTools dial to the Floor Cleaning setting. Turn the power on by pressing the red power switch on the back of the unit with your foot. Turn heater switch (located on side of unit) to the on position. Allow one minute for the built-in heater to warm up before cleaning.

NOTE: The ProHeat will be fully warmed and will provide optimal performance after a minute of continuous heated cleaning.

2.With your foot, press the gray handle release lever located on the back of unit below water tank to detent handle.

3.While pressing the spray trigger, make one slow forward wet pass and another back. Let the built-in heater, BISSELL advanced deep cleaning formula, and DirtLifter PowerBrush do the work for you.

Caution: Do not overwet.

4.Release the spray trigger and make one slow forward and backward pass over the same area to remove any residual dirty water and aid in drying.

5.Repeat cleaning passes until solution

being suctioned up appears clean. Continue passes without pressing the trigger until you can’t see any more water being suctioned up.

w w w . b i s s e l l . c o m

Tip: Thorough vacuuming before deep cleaning will prevent early clogging of the lint trap.

Heater

Switch

WARNING:

To reduce the risk of fire and electric shock due to internal component damage, use only BISSELL cleaning fluids intended for use with the deep cleaner. Non-BISSELL cleaning solutions may harm the machine and void

the warranty.