OPERATING INSTRUCTIONS
CARE & MAINTENANCE
Components
Power “On” Light (red): This light will illuminate when the unit is plugged into the 120V. wall outlet. This light will cycle on and off with the steam ready light.
CAUTION: Read the instructions for “Filling the Water Tank” before opening the Safety Cap.
CAUTION: Always unplug before filling. ALLOW UNIT TO
COOL FOR FIFTEEN (15) MINUTES BEFORE REFILLING.
IMPORTANT: Do NOT add cleaning solutions, scented perfumes, oils or any other chemicals to the water used in this appliance. Use tap water or distilled/purified water if the tap water in your area is very hard.
Remove the funnel slowly and let the remaining water in it to go inside the water tank. Do Not Overfill. Replace the Safety Filler Cap.
WARNING: Allow unit to cool for 15 minutes before refilling. When refilling the steam cleaner while the boiler is still hot, there is a risk that water will squirt back during filling and cause scalding. Extreme care should be taken when refilling the unit. Use caution when opening the Safety/Filler Cap as cap may become hot during use and escaping steam can cause scalding.
If you consistently use demineralized or distilled water, cleaning the tank is unnecessary.
Rinsing Out the Steam Cleaner
Normally, a periodic rinse of your portable steam cleaner will free it from deposits. This is recommended every
Fill the boiler with 20 oz. of water and shake the cleaner vigorously. Tilt the cleaner upside down to empty the boiler of water and any scale deposits.
Descaling Your Steam Cleaner
If the tap water in you area contains a high
To Descale the Steam Cleaner
Step 1: Unplug the steam cleaner from the power source before you descale the boiler. Allow to cool.
Step 2: Fill the boiler with 1 part vinegar and 5 parts water and leave overnight or for a period of approximately 8 hours. Do not screw the safety/filler cap onto the steam cleaner while you are descaling the boiler.
Do not use the steam cleaner while descaling solution is inside the boiler.
Step 3: After the period of soaking, turn the steam cleaner upside down to empty solution from the
Filling or Refilling Your Steam | Step 6: Connect desired attachments | |
Cleaner With Water |
| onto the Flexible Steam Hose. |
IMPORTANT: Always insure that the unit | Step 7: Plug the unit into a standard (120 | |
| volt, grounded) wall receptacle. | |
is “UNPLUGGED” from the wall receptacle |
| |
| Allow approximately | |
prior to initial filling or |
| |
| for vapor to reach its working | |
tank and has been allowed to cool for 15 |
| |
| temperature and pressure. The | |
minutes. Never attempt to fill this unit |
| |
| green ready light will illuminate | |
under a water tap, always use the filling |
| |
| when the unit is ready for use. | |
funnel provided. |
| |
Step 1: Before refilling the steam cleaner, |
| Always point nozzle outlet in a safe |
| direction. | |
make sure that the unit is NOT | NOTE: When the steam cleaner has run | |
plugged in and has been allowed to | out of water, steam output will cease. | |
cool for fifteen (15) minutes. |
|
|
Step 2: Plug the power cord in to an electrical | Fig. 1 | |
outlet and press the steam switch on |
|
|
the hand grip to the “ON” position to |
|
|
vent of any residual steam that is in |
|
|
the boiler. |
|
|
Step 3: Remove the power cord from the |
|
|
electrical outlet and turn the steam |
|
|
switch on the hand grip to the “OFF” |
|
|
position. |
|
|
Step 4: Place the unit on a flat, stable |
|
|
surface. Slowly turn the safety filler |
|
|
cap counter clockwise until it is |
|
|
removed. |
| WARNING: Allow unit to cool |
Step 5: Insert the funnel into the tank |
| |
opening and add 40 US Fl, Oz. |
| for 15 minutes before refilling. |
(1200 ml) of water. (Fig. 1) Place the |
| Use caution when opening the |
funnel in the tank opening as |
| Safety/Filler Cap as cap may |
illustrated in Fig. 1. The funnel has |
| become hot during use and |
been specially designed to show |
| escaping steam can cause |
when the water tank is full. When |
| scalding. |
water starts to come out of the vent hole of the funnel, the tank is full.
level of calcium deposits and you have been using tap water to do your steam cleaning, you should descale your unit after
boiler. Due to the fact that a small amount of solution will be left in the boiler, it is necessary to rinse the boiler out with clean water 2 or 3 times. Your steam cleaner is now ready for use.
5
10