Hoover Shampoo-Polisher Brush pile, Allow carpet to dry, Vacuum dry carpet, Drydeaningcarpet

Page 11

foam. Crisscross area to work foam uniformly into the carpet (see illustration) until the foam disappears. The final strokes over each area should always be in the same direction.

Repeat the process over another 3 ft. x 3 ft. area (Im x Im), overlapping the areas bv several inches. Continue until a 3 ft. (Im) length the width of the carpet or rug has been cleaned.

4. Brush pile

Brush pile in one direction with a long-handled brush, This speeds the drying and gives a uniform appearance. Use a forward and backward stroke. After determin- ing which direction looks best, the last strokes should be in the same direction on all areas of the carpet. Repeat the process of shampooing and brushing until the entire carpet or rug has been cleaned.

5. Allow carpet to dry

The length of time for drying varies; however, overnight drying is desirable whenever possible. The use of an electric fan to speed drying is helpful. If it is necessary to walk on the carpet before it is dry, place towels or white cloths on the traffic areas. If furniture must be replaced before the carpet is dry, use plastic or aluminum foil pads under legs

. . of furniture so metal slides or wood finishes will not stain the carpet or rug.

6. Vacuum dry carpet

Vacuum area thoroughly after it is dry to remove the dry detergent and the dirt loosened by the cleaning process. Frequent vacuuming during the first week after shampooing will enhance the appearance of the carpet.

Drydeaningcarpet

The shampoo-polisher may be used to work dry-cleaning compounds or powders into carpet or rugs. Do not put these substances into the tank and be sure shampoo brushes are dry. Test a small area of carpet for col- orfastness by sprinkling a small amount of powder and wiping with a white cloth. Then check for texture change by using shampoo-polisher with dry brushes in the same area. If color and texture are not affected, follow directions on container for amounts to use and drying time. After compound has dried, vacuum area thoroughly. Install a new disposable bag in vacuum cleaner to insure complete removal of cleaning com- pound and dirt. Frequent bag changes may be necessary when a powdered dry-cleaning compound is used.

10

Image 11
Contents Review this manual before Operating appliance Save Important Safeguards Unpacking Questions or Concerns? How to use AssemblyTo attach tank To remove tank To dispense solution Shampooing carpet and rugs Before you begin Shampoo carpet Using the shampoo PolisherAttach shampoo Brushes Fill tankDrydeaningcarpet Brush pileAllow carpet to dry Vacuum dry carpetWater method Cleaning floorsPage Wood Solvent-base wax Solvent cleaning wax methodWaxing floors Water-base waxFloor WAX Splash guard MaintenanceTo achieve a high lustre finish To keep floors bright and shinyFelt and high lustre polishing pads Shampooer baseBrushes If you have a problem ServiceServicing of Double-Insulated Appliances Floor care hints Accessories