Harman-Kardon AVR 247 0 or, Dolby Digital EX played as, Dolby Pro Logic, See below, Mode Group

Page 48

ADVANCED FUNCTIONS

Table 8 – Surround Modes

Surround Mode

Description

Incoming Bitstream or Signal

 

 

 

Dolby Digital

Provides up to five separate main audio channels and a dedicated

• Dolby Digital 1/0/.0 or .1, 2/0/.0 or .1,

 

low-frequency effects (LFE) channel. May be encoded for Night mode,

3/0/.0 or .1, 2/1/.0 or .1, 2/2/.0 or .1,

 

which allows the user to apply a compression setting that maintains

3/2/.0 or .1

 

intelligibility of softer passages while reducing the loudness of dynamic

• Dolby Digital EX (played as 5.1)

 

passages to avoid disturbing others.

 

 

 

 

Dolby Digital EX

An expansion of Dolby Digital 5.1 that adds a surround back channel

• Dolby Digital EX

 

which may be played through one or two surround back speakers. May

• Dolby Digital 2/2/.0 or .1, 3/2/.0 or .1

 

be manually selected when a non-EX Dolby Digital stream is detected.

 

 

 

 

Dolby Digital Stereo

Delivers a 2-channel downmix of Dolby Digital materials.

• Dolby Digital 1/0/.0 or .1, 2/0/.0 or .1,

 

 

3/0/.0 or .1, 2/1/.0 or .1, 2/2/.0 or .1,

 

 

3/2/.0 or .1

 

 

• Dolby Digital EX

 

 

 

Dolby Pro Logic II

Analog decoder that derives five full-range, discrete main audio channels

See below.

Mode Group

from matrix surround-encoded or 2-channel analog sources. Four

 

 

variants are available.

 

 

 

 

Dolby Pro Logic II

Variant of Dolby Pro Logic II that is optimized for movie and

• Dolby Digital 2.0 or 2.1

Movie

television programs.

• Analog (2-channel)

 

 

• Tuner

 

 

• PCM (32kHz, 44.1kHz, 48kHz, 96kHz)

 

 

 

Dolby Pro Logic II

Variant of Dolby Pro Logic II that is optimized for music selections.

• Dolby Digital 2.0 or 2.1

Music

Allows adjustment of sound field presentation in three dimensions:

• Analog (2-channel)

 

• Center Width (adjusts width of vocal soundstage)

• Tuner

 

• Dimension (adjusts depth of soundstage)

• PCM (32kHz, 44.1kHz, 48kHz, 96kHz)

 

• Panorama (adjusts wraparound surround effect)

 

 

 

 

Dolby Pro Logic II

Variant of Dolby Pro Logic II that emphasizes use of the surround

• Dolby Digital 2.0 or 2.1

Game

channels and subwoofer for total immersion in the video gaming

• Analog (2-channel)

 

experience.

• Tuner

 

 

• PCM (32kHz, 44.1kHz, 48kHz, 96kHz)

 

 

 

Dolby Pro Logic

Original version of Dolby Pro Logic that steered a mono signal

• Dolby Digital 2.0 or 2.1

 

containing information below 7kHz to the surround channels.

• Analog (2-channel)

 

 

• Tuner

 

 

• PCM (32kHz, 44.1kHz, 48kHz, 96kHz)

 

 

 

Dolby Pro Logic IIx

An expansion of Dolby Pro Logic II that adds a surround back channel

 

Mode Group

which may be played through one or two surround back speakers. The

 

 

Dolby Pro Logic IIx modes may be selected not only with Dolby Digital bit-

 

 

streams, but thanks to the AVR 247’s post-processor, they may also be used

 

 

with some DTS bitstreams to add a surround back channel to 5.1 modes.

 

 

 

 

Dolby Pro Logic IIx

This mode is similar to Dolby Pro Logic II Movie, with an added surround

• Dolby Digital 2/0/.0 or .1, 2/2/.0 or .1,

Movie

back channel. In addition, it may be selected even when some types of

3/2/.0 or .1, EX

 

DTS signals are present for a somewhat different presentation.

• DTS 2/2/.0 or .1, 3/2/.0 or .1

 

 

• DTS 96/24

 

 

• DTS-ES Matrix

 

 

• DTS-ES Discrete

 

 

• Analog (2-channel)

 

 

• Tuner

 

 

• PCM (32kHz, 44.1kHz, 48kHz, 96kHz)

 

 

 

48

Page 47 Page 49
Image 48
Page 47 Page 49
Contents AVR Safety Information Outdoor Antenna Grounding. If an outside antennaImportant Safety Information Staple Invoice Here Table of Contents Introduction Thank you for choosing Harman KardonAudio Section Surround ModesSupplied Accessories Audio InputsAudio/Video Inputs With S-Video Digital Audio InputsFRONT-PANEL Controls Navigation Adjust Input Indicators Main PowerCoaxial Video Switch Select Audio InputsREAR-PANEL Connections Video 1, Video 2, Video 3 and DVD Audio/Video InputsREAR-PANEL Connections DVD A/V Remote Control Functions Channel Input Selector Press this button to selectBridge/DMP Controls an iPod docked in The Bridge DSP Surround On-Screen Display Track Skip Transport ControlsRemote Control Functions Introduction to Home Theater Surround ModesTypical Home Theater System Multichannel AudioConnecting Source Devices to the AVR ConnectionsTypes of Connections Speaker ConnectionsAudio Connections Digital AudioVideo Connections Digital VideoAnalog Video FM antenna uses a 75-ohm F-connector. See Figure AntennasRS-232 Serial Port Speaker Placement Placement of Surround Speakers in a 5.1-Channel SystemFront Speaker Placement Placement of Surround Speakers in a 7.1-Channel SystemSubwoofer Placement Installation Step One Connect the SpeakersStep Two Connect the Subwoofer Step Three Connect the AntennasRecommended Source Component Connections Audio Connections Video ConnectionsTiVo or other Or Video 1 Composite Video Input Video Video 2 Analog InputsVideo 1 Source Video 3 SourceVideo 2 Source Video 4 SourceHdmi 1 TapeNo video connections are needed Step Six Plug in AC Power Step Five Connect the Video DisplayStep Seven Insert Batteries in Remote Turn on your source deviceStep Ten Install a Multiroom System Optional Enter a code from , aboveVideo Cable, Satellite Press the Standby/On Switch on the front panel. See Figure Step Eleven Turn On the AVRTwo steps are required the first time you turn on the AVR Initial Setup Using the On-Screen Menu SystemConfigure the AVR 247 Using EzSet/EQ EzSet/EQ ScreenWhat EzSet/EQ Does TerminalsConfigure Sources EzSet/EQ EqualizationSource Input Default Video Input Only upper case letters are available for titlesSource Input CoaxYou are now ready to begin enjoying your new receiver Sleep Timer Volume ControlOperation Turning On the AVRHeadphones Tone ControlsSource Selection Audio Input Selection Video Input SelectionChannel Direct Inputs Using the Tuner We recommend that you connect this player as followsTo store a station in one of the 30 presets see Figure Use the Numeric Keys to enter the desired preset numberXM Radio Operation Using TheBridgeTM To store a channel in one of the 40 preset locationsRecording IPod Function Selecting a Surround Mode Analog Audio Signals Digital Audio SignalsAdvanced Functions Audio Processing and Surround SoundRepeated Surround Setup Menu Screen Default Modes Dolby Surround SettingsNight Mode Mode Group Panorama adjusts wraparound surround effect Dolby Pro Logic0 or Dolby Digital EX played asSurround Mode Description Incoming Bitstream or Signal Mode Group Enveloping sound field is desiredDolby Digital 2/0/.0 or ReferenceMode Group Appropriate when a subwoofer is usedDTS Neo6 DTS 2/2/.0 or .1, 3/2/.0 orManual Setup Step Three Manual Setup MenuStep One Determine Speaker Size Step Two Measure Speaker DistancesLarge setting Speaker Size MenuDelay Adjust Menu Speaker Crossover MenuMove the cursor to the left to select the next submenu Step Four Setting Channel Output Levels Manually Using the Remote Control With the Test ToneHowever, if you prefer to make these adjustments manually, Make sure all speakers have been connected correctlyVideo Adjustments Using the Front-Panel or Remote-Control Channel CommandUsing the Full-OSD Menu Installing a Multiroom System Multiroom OperationSystem Settings Operating the Multiroom SystemAdvanced Remote Control Functions Dim FunctionPunch-Through Programming To dim the displayResetting the Remote Processor ResetMacros MemoryTroubleshooting Guide AVR 247 Technical Specifications DTSAppendix Default settings, worksheets, remote product codes Table A1 Source Input Setting DefaultsTable A2 Speaker/Channel Setting Defaults Table A3 Delay Setting DefaultsTable A4 Source Input Settings Table A5 Speaker/Channel SettingsAuto Poll Surround Mode Tone Mode Bass Treble Video Mode Title Video Input Audio InputTable A6 Remote Control Codes Table A7 System SettingsTape Cassette VCR, PVR, DVD, Cable, SatelliteRemote Control Function List Reference Remote Control Function List Table A8Table A8 FAVAiwa Table A9 Table A10 Remote Control Product Codes VCR Table A11 Remote Control Product Codes CD Table A13 Remote Control Product Codes SAT Table A12 Remote Control Product Codes DVDTable A16 Remote Control Product Codes Table A15 Remote Control Product Codes CBLPage
Top Page Image Contents