Harman-Kardon Explore Harman Kardon AVR 247 Specifications and Features

Page 61

AVR 247 TECHNICAL SPECIFICATIONS

Audio Section

Stereo Mode

Continuous Average Power (FTC)

65 Watts per channel, 20Hz–20kHz,

@ <0.07% THD, both channels driven into 8 ohms

Seven-Channel Surround Modes

Power per Individual Channel

Front L&R channels:

50 Watts per channel

@ <0.07% THD, 20Hz–20kHz into 8 ohms

Center channel:

50 Watts @ <0.07% THD, 20Hz–20kHz into 8 ohms

Surround (L & R Side, L & R Back) channels: 50 Watts per channel

@ <0.07% THD, 20Hz–20kHz into 8 ohms

Input Sensitivity/Impedance

 

Linear (High-Level)

200mV/47k ohms

Signal-to-Noise Ratio (IHF-A)

100dB

Surround System Adjacent Channel Separation

Pro Logic I/II

40dB

Dolby Digital (AC-3)

55dB

DTS

55dB

Frequency Response

 

@ 1W (+0dB, –3dB)

10Hz – 130kHz

High Instantaneous

 

Current Capability (HCC)

±35 Amps

Transient Intermodulation

 

Distortion (TIM)

Unmeasurable

Slew Rate

40V/µsec

FM Tuner Section

 

Frequency Range

87.5 –108.0MHz

Usable Sensitivity

IHF 1.3µV/13.2dBf

Signal-to-Noise Ratio

Mono/Stereo 70/68dB

Distortion

Mono/Stereo 0.2/0.3%

Stereo Separation

40dB @ 1kHz

Selectivity

±400kHz, 70dB

Image Rejection

80dB

IF Rejection

90dB

The AVR 247 is Simplay HD-verified for compatibility via the HDMI connection with other Simplay HD-verified products.

Please register your AVR 247 on our Web site at

www.harmankardon.com.

NOTE: You’ll need the product’s serial number.

At the same time, you can choose to be notified about our new products and/or special promotions.

AM Tuner Section

 

 

Frequency Range

520–1720kHz

 

Signal-to-Noise Ratio

45dB

 

Usable Sensitivity

Loop 500µV

 

Distortion

1kHz, 50% Mod 0.8%

 

Selectivity

±10kHz, 30dB

 

Video Section

 

 

Television Format

NTSC

 

Input Level/Impedance

1Vp-p/75 ohms

 

Output Level/Impedance

1Vp-p/75 ohms

 

Video Frequency Response

 

 

(Composite and S-Video)

10Hz–8MHz (–3dB)

 

Video Frequency Response

 

 

(Component Video)

10Hz–100MHz (–3dB)

 

HDMI

Audio and video processing

 

General

 

 

Power Requirement

AC 120V/60Hz

 

Power Consumption

65W idle, 540W maximum

 

 

(7 channels driven)

 

Dimensions

(Product)

(Shipping)

Width

17-5/16 inches (440mm)

21-7/8 inches (555mm)

Height

6-1/2 inches (165mm)

10-1/2 inches (266mm)

Depth

15 inches (382mm)

18-5/16 inches (465mm)

 

(Product)

(Shipping)

Weight

30.0 lb (13.6kg)

35.0 lb (15.9kg)

Depth measurement includes knobs, buttons and terminal connections.

Height measurement includes feet and chassis.

All features and specifications are subject to change without notice.

Harman Kardon and Logic 7 are trademarks of Harman International Industries, Incorporated, registered

in the United States and/or other countries. EzSet/EQ, TheBridgeTM and Designed to Entertain are trademarks of Harman International Industries, Incorporated.

Apple, iTunes and iPod are trademarks of Apple Inc., registered in the U.S. and other countries. Shuffle is a trademark of Apple Inc.

Audiovox is a registered trademark of Audiovox Corporation.

Blu-ray Disc is a trademark of the Blu-ray Disc Association.

CEA is a registered trademark of the Consumer Electronics Association.

Cirrus Logic is a registered trademark of Cirrus Logic, Inc.

Dolby, Pro Logic and the double-D symbol are trademarks of Dolby Laboratories. Manufactured under license from Dolby Laboratories.

“DTS” and “DTS ESINeo:6” are registered trademarks of DTS, Inc. “96/24” is a trademark of DTS, Inc. Faroudja and DCDi by Faroudja are registered trademarks of Genesis Microchip Inc.

HD-DVD is a trademark of the DVD Format/Logo Licensing Corporation (DVD FLLC).

HDMI is a trademark of HDMI Licensing LLC.

Microsoft and Xbox are registered trademarks of Microsoft Corporation in the United States and other countries.

SACD is a trademark of Sony Corporation.

The Simplay HD logo and the Simplay, Simplay HD and Simplay Labs trademarks are owned by Silicon Image, Inc. and are used under license from Silicon Image, Inc. and/or Simplay Labs, LLC.

TiVo is a registered trademark of TiVo Inc.

XM and XM Ready are registered trademarks of XM Satellite Radio.

61

Image 61
Contents AVR Outdoor Antenna Grounding. If an outside antenna Safety InformationImportant Safety Information Staple Invoice Here Table of Contents Thank you for choosing Harman Kardon IntroductionAudio Section Surround ModesAudio Inputs Supplied AccessoriesAudio/Video Inputs With S-Video Digital Audio InputsFRONT-PANEL Controls Main Power Navigation Adjust Input IndicatorsCoaxial Video Switch Select Audio InputsVideo 1, Video 2, Video 3 and DVD Audio/Video Inputs REAR-PANEL ConnectionsREAR-PANEL Connections DVD A/V Channel Input Selector Press this button to select Remote Control FunctionsBridge/DMP Controls an iPod docked in The Bridge Track Skip Transport Controls DSP Surround On-Screen DisplayRemote Control Functions Surround Modes Introduction to Home TheaterTypical Home Theater System Multichannel AudioConnections Connecting Source Devices to the AVRTypes of Connections Speaker ConnectionsDigital Audio Audio ConnectionsDigital Video Video ConnectionsAnalog Video Antennas FM antenna uses a 75-ohm F-connector. See FigureRS-232 Serial Port Placement of Surround Speakers in a 5.1-Channel System Speaker PlacementFront Speaker Placement Placement of Surround Speakers in a 7.1-Channel SystemSubwoofer Placement Step One Connect the Speakers InstallationStep Two Connect the Subwoofer Step Three Connect the AntennasAudio Connections Video Connections Recommended Source Component ConnectionsTiVo or other Or Video 1 Composite Video Input Video Video 2 Analog InputsVideo 3 Source Video 1 SourceVideo 2 Source Video 4 SourceTape Hdmi 1No video connections are needed Step Five Connect the Video Display Step Six Plug in AC PowerTurn on your source device Step Seven Insert Batteries in RemoteEnter a code from , above Step Ten Install a Multiroom System OptionalVideo Cable, Satellite Step Eleven Turn On the AVR Press the Standby/On Switch on the front panel. See FigureTwo steps are required the first time you turn on the AVR Using the On-Screen Menu System Initial SetupEzSet/EQ Screen Configure the AVR 247 Using EzSet/EQTerminals What EzSet/EQ DoesEzSet/EQ Equalization Configure SourcesOnly upper case letters are available for titles Source Input Default Video InputSource Input CoaxYou are now ready to begin enjoying your new receiver Volume Control Sleep TimerOperation Turning On the AVRTone Controls HeadphonesSource Selection Video Input Selection Audio Input SelectionChannel Direct Inputs We recommend that you connect this player as follows Using the TunerUse the Numeric Keys to enter the desired preset number To store a station in one of the 30 presets see FigureXM Radio Operation To store a channel in one of the 40 preset locations Using TheBridgeTMRecording IPod Function Selecting a Surround Mode Digital Audio Signals Analog Audio SignalsAdvanced Functions Audio Processing and Surround SoundRepeated Surround Setup Menu Screen Dolby Surround Settings Default ModesNight Mode Panorama adjusts wraparound surround effect Dolby Pro Logic Mode Group0 or Dolby Digital EX played asMode Group Enveloping sound field is desired Surround Mode Description Incoming Bitstream or SignalDolby Digital 2/0/.0 or ReferenceAppropriate when a subwoofer is used Mode GroupDTS Neo6 DTS 2/2/.0 or .1, 3/2/.0 orStep Three Manual Setup Menu Manual SetupStep One Determine Speaker Size Step Two Measure Speaker DistancesSpeaker Size Menu Large settingSpeaker Crossover Menu Delay Adjust MenuMove the cursor to the left to select the next submenu Using the Remote Control With the Test Tone Step Four Setting Channel Output Levels ManuallyHowever, if you prefer to make these adjustments manually, Make sure all speakers have been connected correctlyUsing the Front-Panel or Remote-Control Channel Command Video AdjustmentsUsing the Full-OSD Menu Multiroom Operation Installing a Multiroom SystemOperating the Multiroom System System SettingsDim Function Advanced Remote Control FunctionsPunch-Through Programming To dim the displayProcessor Reset Resetting the RemoteMacros MemoryTroubleshooting Guide DTS AVR 247 Technical SpecificationsTable A1 Source Input Setting Defaults Appendix Default settings, worksheets, remote product codesTable A2 Speaker/Channel Setting Defaults Table A3 Delay Setting DefaultsTable A5 Speaker/Channel Settings Table A4 Source Input SettingsAuto Poll Surround Mode Tone Mode Bass Treble Video Mode Title Video Input Audio InputTable A7 System Settings Table A6 Remote Control CodesTape Cassette VCR, PVR, DVD, Cable, SatelliteRemote Control Function List Reference Table A8 Remote Control Function ListFAV Table A8Aiwa Table A9 Table A10 Remote Control Product Codes VCR Table A11 Remote Control Product Codes CD Table A12 Remote Control Product Codes DVD Table A13 Remote Control Product Codes SATTable A15 Remote Control Product Codes CBL Table A16 Remote Control Product CodesPage