GE GXRV10, GXRM10, PNRV18, PNRV12 Sanitizing the System for Models PNRQ15, PNRQ20

Page 3

SANITIZING THE SYSTEM FOR MODELS PNRQ15, PNRQ20

See your Reverse Osmosis System Owner's Manual for complete Sanitization Instructions.

I. Turn off' the icemaker (if attached to the system).

2.Turn off' the water supply to dm systeIn.

3.Turn on tile RO f_mcet to drmn that tank (it may take several

minutes). Tunl OFF the faucet when tile tank is emp/y.

A--CAUTION:Failuretoclosethewetersupplvalveortodra,.

the tank will cause water to sprayor run when canisters are removed.

4. Remove the prefilter, posltilter and RO canister by relating to

lhe left about 1/3 turn.

5. Fill tile empty canister labeled "Sanifiz2ttion Canister" with

water to widfin 1" of ltle tipper opening. Add 1 oz. (2 Tbsp.)

of ordinary household [)leach. Install canister into the prefilter

canister position hy mining Io dm right about 1/3 turn until

lhe Mignment marks line up mid lhe cmfister stops.

6.Install by-lra_ss plugs into file RO canister and posit[her opening in tile manifbld hy mining to tile right about 1/3 turn until file

alignment marks fine tip mid tile cmfister stops.

Z Turn on tile water supply. Turn oil the _hucet until water begdns lo flow from file faucet, then turn tile faucet ore Allow ltle sysleIll tO fill ff)r 10 minutes.

Turn tile fimcet on and allow water to flow fbr 20 minutes,

or until bleach odor is gone. Turn off' tile water supply again. Turn on dm faucet to drain dm systeIn.

9.Once tile system is drained, lure the l_ucel offand remove the canister and plugs by turifing to the left about 1/3 turn. Keep lhese in a safe place until needed tile next time.

10.If y_m are replacing the cmfisters, remove dm foil oil the mp

of tile new replacement filler canisters or RO cmfister. Install cmfislers into the Inmfifi)ld by turning to tile right about 1/3

lure until dm alignment marks line up mid ltle canisters stop.

DO NOT OVERTIGHTEN.

11.Turn on tile water supply to fill lhe system (it may take up to 4 hours). Check for leaks.

PNRQ15:Remove the battery tray and replace lhe battery to reset timer iI1 [_ucel base.

PNRQ2_. Remove tile batteries from dm battery holder and

replace batteries to reset timer and 900 gallon monitor fimctions.

12.If the prefilmr and poslfiher are replaced, turn the faucet on and empty tile filled storage rzalk.

13.Once lhe storage tank is flail, turn on ltle icemaker.

RO product water faucet mounted through sink

/

3/8" drain

Fig. 6

Tee

Disposer

, TO icemaker

hflet

Tee

_utlet

Reservoir

Image 3
Contents KIT Contents Installation InstructionsTitting ,,1 Connecting to the IcemakerFormodels GXRV10, GXRM10, PNRV12 Sanitizing the System for Models GXRV10, GXRM10, PNRV12Sanitizing the System for Models PNRQ15, PNRQ20 Lift tile lever oil Ihe Connecting the Auxiliary Tank for Model PNRV18Tile water supply valve Hg ShutConnecting to the Icemaker for Model PNRV18 Chlorine will destroy the RO cartridge Be sure hands have been cleaned with an anti-bacterial soapSanitizing the System For Model PNRV18