Kenmore 625.39376 warranty Recharge Time Remaining and Valve Position Indicators, Program Memory

Faceplate Timer Features

AVERAGE DAILY GALLONS or LITERS

Press the SELECT 2 button again to show the average number of gallons (or liters) of soft water the household uses each day. This water usage figure is adjusted daily by the faceplate timer. To turn this display off, press the

SALT SIGNAL LEVEL LEVEL

8

7

6

5

4

3

2

PM

SELECT 2 button once again.

RECHARGE TIME REMAINING AND VALVE POSITION INDICATORS

1AVG. DAILY GALLONS

FIG. 45

One of the valve position indicators (Serv, Fill, Brine, Bkwsh, Rinse) is displayed while the softener is recharg- ing. RECHARGE flashes in the display and, beginning with Brine, the minutes of recharge remaining before return to service appears in place of the present time. When the valve is moving from one cycle to another, both position indicators are flashing.

PROGRAM MEMORY

If electrical power to the softener goes off, the time dis- play is blank but the face plate timer keeps the correct time for about 6 hours. When electrical power comes on again, you have to reset the present time only if the dis- play is flashing. The HARDNESS and RECHARGE TIME never require resetting unless a change is desired. Even if the timer is incorrect after a long power outage, the sof- tener works as it should to keep your water soft. However, regenerations may occur at the wrong time of day until you reset the timer to the correct time of day.

Valve Position

Indicators

SALT	SIGNAL	SERV
LEVEL	LEVEL	FILL
			MIN
	8	BRINE
	7	BKWSH	RECHARGE
	6	RINSE
			TIME REMAINING
	5
	4
	3
	2
	1

Recharge Time

Remaining

FIG. 46

ERROR CODE

An error code could appear in the face plate display if a problem occurs in the softener electronics. Turn to the Troubleshooting section to resolve the problem and/or call the Kenmore Water Line number listed below.

KENMORE’S ULTRA CLEANSING FEATURE

The ultra cleansing feature keeps larger particles of sedi- ment from entering the home’s plumbing system. As water passes through the softener, the larger sediment particles are collected in the integrated basket and then rinsed to the drain before each regeneration. The ultra cleansing feature provides added protection for water using appliances by reducing the chance of larger parti- cles entering the various products valves and screens. An extra backwash will be preprogrammed into the electron- ics by the factory. This extra backwash will help keep the ultra cleansing feature screen clean.

Important: The ultra cleansing feature is not intended to replace pretreatment filtration. For problem water applications, additional sediment filtration is recom- mended.

Sears offers a full line of dedicated sediment filtration products.

SALT SIGNAL

LEVEL LEVEL

8

7

6

5

4

3

2

1

FIG. 47

Ultra Cleansing Screen

Top Distributor

FIG. 48

Questions? Call The Kenmore Water Line 1-800-426-9345

25