Kenmore 625.347001 owner manual Install Drain Adapter, Install Faucet, Prepare Mounting Hole

-- STEP 2: INSTALL DRAIN ADAPTER --

JNote: Running the drain tubing directly to a floor drain, sump, standpipe, laundry tub, etc., as shown on page 18, is preferred. However, if that is not pos- sible or practical, the included drain adapter installs in the sink drain pipe, always above or ahead of the p- trap (FIG. 4). Be sure to comply with your local plumbing codes. Other drain pipe fittings, in addi- tion to the adapter, may be needed.

J The drain adapter fits 1-1/2” sink drain pipe.

J The adapter installs directly onto the sink tailpiece as typically shown in FIG. 4 and 5.

J Locate so drain tubing from the faucet (installed in step 1, page 8) makes a straight run to the adapter, without dips, loops, low spots or kinks.

FIG. 4

A

B

drain

adapter

Note: Consult a plumber if you are not familiar with plumbing procedures.

1.Use a ferrule and nut to assemble the drain tubing connector to the drain adapter (FIG. 5). Turn the con- nector to about 45_from the 12:00 position, as shown (to 10:00 or 2:00 position as needed). Tighten the nut securely.

2.Carefully disassemble the sink drain pipe and clean the tailpiece to assure a leak-tight fit.

3.Install the drain adapter onto the sink tailpiece, using a ferrule and nut. Snug the nut, but do not tighten.

Note: If needed, to make fit, you can cut to shorten the unthreaded end of the adapter. Do not cut too short so the adapter will make a leak-tight seal with the connecting fitting.

4.Assemble the p- trap to the drain adapter, and oth- er drain pipe fittings as required (check codes) to complete the drain run.

5.Tighten all connections, but do not overtighten and break plastic fittings.

FIG. 5

sink tailpiece

nut

ferrule

drain adapter	black
		45_	45_
ferrule	collet
	nut
cut, if
needed		10:00	2:00
drain tubing
connector

-- STEP 3: INSTALL FAUCET --

A. PREPARE MOUNTING HOLE

1.Select 1 of the following places for the faucet. Be sure it will fit flat against the surface, and there is space underneath for tubing (see FIG. 8, page 8).

'Use an existing sink top hole for a spray hose or other faucet. A 1”to 1-1/4”diameter hole is need- ed.

'Drill a new hole in the countertop next to the sink.

'Drill a new hole in the sink top.

CAUTION: To avoid damaging a sink beyond re- pair, consult a qualified plumber or installer for guides to drill holes in porcelain or stainless steel.

2.If drilling is needed, make the 1”to 1-1/4”diame- ter hole.

3.Place plumbers putty around the drilled hole (FIG.

6) to prevent water leakage around the base of the faucet.

6