OPERATION PART /INDICATION PART
▶Operation Part/Indication Part
How to Use
5Hot water button
To use hot water, press the hot button, check if the hot water mode lamp goes on, and extract water. (However, the mode automatically returns to cold water mode three seconds after hot water has been extracted.)
7Cold water button
Press the cold button, check if the cold water mode lamp is on, and extract water.
6Room water button
To use room water, press the room button and extract water.
8Light detection sensor Detects the ambient light, reducing energy usage by automatically decreasing the operation frequency of the cooler.
■ When using the hot water lock
Press the hot water lock for three seconds. Check if the hot water lock lamp comes on.
■ Light detection sensor setting function
Press the hot and cold buttons together for |
|
|
three seconds; the hot water mode lamp |
|
|
flickers as shown in the picture with a “pinging” |
|
|
sound, and the system enters the setting |
|
|
mode. |
|
|
Press the cold button once; the cold water | set | unset |
mode lamp comes on, and the light detection |
|
|
sensor function is set. |
|
|
(When the cold water mode lamp goes out, the |
|
|
Operation Part/Indication Part
■When using cold water
Press the cold button, and check if the cold water mode lamp is on.
■When using room water
Press the room button, and touch the extraction part.
■To use hot water
Press the hot button, and check if the hot water mode lamp is on.
20
function is disabled.) |
After setting the mode, press the room button |
for three seconds; the system saves the last |
set mode and converts to standby mode. |
■ Fixed quantity extraction function
Press the hot and cold buttons together for |
|
three seconds; the hot water mode lamp |
|
flickers as shown in the picture with a “pinging” |
|
sound, and the system enters the setting mode. |
|
The quantity is adjusted each time the hot |
|
button is pressed (120cc �200cc �300cc � |
|
120cc), and the hot water mode lamp goes on |
|
according to each quantity phase. After | 120cc 200cc 300cc |
completing the mode setting, |
|
press the room button for more than three |
|
seconds; the system saves the last set mode |
|
and converts to standby mode. |
|
※To use both the hot water and cold water modes, press each button for more than three seconds. Once both hot water and cold water mode lamp go on, you can use them.
※“Light detection sensor” is set to disabled status at the initial usage
21