Install baseplate 06329XXX, (optional - not included)
Position the baseplate and gasket on the faucet deck. From under the sink, install the mounting flanges and tighten the mounting collars by hand.
The baseplate can be used on a kitchen sink with fewer than three holes. Remove and disgard the threaded studs on the bottom of the baseplate. Align the baseplate and the gasket visually.
Install the faucet:
Remove the mounting nut, metal washer, fiber washer and spacer from the faucet.
Sit the faucet on the mounting surface.
If the mounting surface is thin (less than 1 3/8”) and there is sufficent space, install the gray plastic spacer. If the mounting surface is greater than 1 3/8”, or if there is insuf- ficient space, omit the spacer.
Loosely install the fiber washer, metal washer and mounting nut.
Check the orientation of the faucet. The spout swivels 150o and should swivel evenly to the right and to the left. If it is satisfactory, finish tightening the mounting nut and the tension- ing screws.
Install the handspray hose: slide the nut, cone washer, brass washer and black rubber washer over the end of the connecting hose. Hold the handspray hose steady while tightening the nut. Do not allow the handspray hose to twist. Finish tightening the nut with a wrench.