4.3.5 Verify38BTemperature/Dewpoints
To display Temperature/Dewpoints on the NAV Weather Page:
1.Select the NAV Weather Page.
2.Press CRSR. The upper left hand corner data field flashes.
3.Turn the small right knob and select ‘TEMP/DP’.
4.Press CRSR. The Temperature/Dewpoints are displayed on the NAV Weather Page similar to FigureX
4-7,X if available.
Figure 4-7. Temperature/Dewpoints Page
NOTE
For all 400/500 Series units: After verifying that all weather products have been received, leave unit on for an additional 1.5 hours to allow subscription lock-in process to take place.
4.4 Refreshing20B
If the unit is not activated after 1.5 hours a ‘refresh’ maybe needed. To accomplish this go to the website www.xmradio.com/refresh as explained in Section 2X .2.X When asked for the Radio ID number on the website, enter the Data ID number and then follow the steps as outlined on the website. If you still are having trouble, call Garmin technical support using the telephone numbers listed on page iii.
4.5 Deactivating21Band Reactivating the GDL 69/69A
When the GDL 69/69A is not properly activated, in some cases it may be necessary to perform a full deactivation and reactivation of the system in order to make it work properly. This procedure is complicated and should never be attempted without the guidance of Garmin AT technical support personnel. Please contact Garmin AT technical support using the telephone numbers listed on page iii.
XM Activation Procedures | Page 17 |
Rev. H |