H2O Audio iDV1-75, iDV1-5A1 manual

Page 13

Q:Why is the Red LED ﬂashing?

A:The iDive300 is designed to measure battery-life of the 3-AA batteries that are used to power

the “Made for iPod” connection electronics and the power ampliﬁer. The Red LED will start to ﬂash when the batteries have approximately 25% charge remaining. Note, the battery indicator of the iPod does not reﬂect the power remaining in the 3-AA batteries.

Notes:

-“Made for iPod” means that an electronic accessory has been designed to connect speciﬁcally to iPod and has been certiﬁed by the developer to meet Apple performance standards.

-Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.

Image 13

Contents Page w w w . H 2 O A u d i o . c o m D e p t h R a t i n g 3 0 0 f t / 9 0 mConnector Cable Height Adjuster Holes LED lights Battery CoverMask Clip Speaker iPod Control Buttons Cam Knob Depth Rating 300ft / 90m Cam Knob LockInstructions QuickstartIII.Install batteries 3 AA V. Install iPod VI. Turn on iPodCleaning & Storing the O-ring ReplacementPrior to use verify Do NOT use ifTo Close Case IV. Install batteriesInsert and height adjuster reference Included insert and height adjustersHeight Adjuster Height AdjusteriPod Authentication Power On/OffVI. Insert iPod VII. OperationIn case of a Steady Red LED IX. General Storage ProceduresIn case of a Flashing Red LED Mode ButtonXII. General Use Notice X. Contact UsXIII. Warranty Coverage To Obtain Service FAQ’sCustomer Support Hours and Contact Information XVI. ReturnsPage w w w . H 2 O A u d i o . c o m