Mounting frame to wall | Bradley Smoker SS-3/AST/JUV, SS-3/AST/STD

	Express® Lavatory System SS-Series
Installation Instructions - For Service Only	SS-3/AST/STD, SS-3/AST/JUV

Installation Instructions continued . . .

Step 2: Mounting frame to wall

1.Remove the ten Torx-head screws securing the panel to the frame, and remove the panel (see Figure 3).

Note: Scuff panel does not need to be removed.

2.Position the frame against the wall, ensuring that it is level. If necessary, insert shims under the frame until level.

Note: When mounted, the Standard and Juvenile Height frames should rest on the floor.

IMPORTANT: Anchoring the frame to a wall that is not flat may cause the frame to bend. If necessary, install shims to compensate for any wall distortion.

1-1/2” NPT DRAIN STUB-OUT

1/2” NPT HOT AND COLD

SUPPLIES OR TEMPERED SUPPLY - STUB-OUTS

Figure 2

3.Ensure that the back of the frame is flat against the wall. If wall is not flat, insert shims behind the frame to ensure that it will not bend when anchored.

4.Once you have positioned the frame such that it is level and resting on the floor and flat against the wall or shimmed, use the 3/8" bolts and washers to mount the frame to the wall (see Figure 4).

		(6) 3/8" BOLT
	FRAME	AND WASHER
	FRAME
PANEL
PANEL

FRAME

(10) TORX-HEAD SCREW

Figure 3	Figure 4

Installation Instructions continue . . .

Bradley Corporation • 215-1238 Rev. C; EN 03-813

5/11/04