Bradley Smoker SS-3/AST/JUV, SS-3/AST/STD Rough, Installation Instructions continue

	Express® Lavatory System SS-Series
Installation Instructions - For Service Only	SS-3/AST/STD, SS-3/AST/JUV

Installation Instructions

Step 1: Rough in

Note: See Figure 1a below (for Standard Height) and Figure 1b on page 6 (for Juvenile Height) when roughing in the Express®.

IMPORTANT: Flush the supply lines before making connections. Debris in supply lines will cause the valves to malfunction.

IMPORTANT: Dimensions shown in Figure 1a are for Standard Height and in Figure 1b for Juvenile Height.

1.Rough in 1/2" NPT hot and cold supply lines through wall at dimensions shown.

2.Rough in 1-1/2" NPT drain waste connection through wall at dimensions shown.

3.Install (8) 3/8" wall anchors with a minimum pull-out rating of 1,000 lbs. (supplied by installer) at the locations shown in Figures 1a and 1b.

SS-3/AST/STD Express® Lavatory System (Standard Height)

(MM)

32"

(813)

28-5/8"

(727)

23-1/2"

(597)

11-3/8"

(289)

Figure 1a

38-1/2"						38-1/2"
(978)						(978)
	24-3/8"			24-3/8"
	(619)			(619)
					4-3/8"
					(111)
2-3/4"	17-7/16"
		(70)	(443)

1-1/2" NPT DRAIN - STUB OUT 3-1/2" (89) FROM WALL

(8) 3/8" WALL
ANCHORS WITH
		Finished
MINIMUM PULLOUT		Floor
RATING OF 1,000
LBS.
	CENTERLINE

1/2" NPT HOT AND COLD SUPPLIES OR TEMPERED SUPPLY - STUB OUT 2" (50) FROM WALL

15-1/4"

(387)

Installation Instructions continue . . .

Bradley Corporation • 215-1238 Rev. C; EN 03-813 5/11/04 5