Installation
Instructions
Aerada 1000 Series
Gooseneck Faucet
WARNING
Read this entire installation manual to ensure proper installation, then file these instructions with the owner or maintenance department.
Flush all the water supply lines before making connections, then make sure the water supply is turned off before beginning installation.
Do not use pipe dope on faucet and supply connections. Possible solenoid contamination could occur and will void any warranty. Teflon tape is the recommended sealant. Use plumber’s putty only to seal the faucet to the deck.
The installation site should have access to an electrical box with 120 volt AC, 60 Hz cycle for input to a transformer. When installing the transformer, the electrical box should be located within six feet of the sink.
The DC faucets are powered by four “AA”
Product warranties may be found under “Product Information” on our web site at www.bradleycorp.com.
Compliance and conformity to local codes and ordinances is the responsibility of the installer.
P.O. Box 309, Menomonee Falls, WI | ||
© 2004 Bradley Corporation | Phone: | |
Page 1 of 8 | 9/23/04 | http://www.bradleycorp.com |