Bradley Smoker 232-007, S53-308, S53-307, S53-309, S53-306 Troubleshooting, Beeps

Installation InstructionsAerada 1000 Series Gooseneck Faucet

Troubleshooting

Whenever new batteries are installed, AC power is applied,	The following chart provides details concerning the number
or a manual reset button is pressed, the LED on the	of beeps and possible errors associated with them .
electronics cover will blink and an audible indicator chirps	1	Beep:	Indicates low battery.
twice per second whenever hand presence is detected.
After 8 minutes, the LED and buzzer function stops.	2	Beeps:	Calibration out of range (environment too
If an error occurs, the LED will blink and the buzzer will			reflective).
sound every 30 seconds to assist in diagnosing the	3	Beeps:	Room infrared level out of range; too much
problem. When corrective action is taken the LED and
			sunlight, heat lamp present, etc.
buzzer will stop.
	4	Beeps:	Solenoid short circuit.
	5	Beeps:	Solenoid unplugged or loose/broken solenoid
			connection.
	Refer to Troubleshooting Chart below and on page 8 for
	further troubleshooting information.

Problem	Check	Possible Solution
Water runs continuously.	Debris in solenoid (no beeps).	Disassemble solenoid and inspect/clean parts.
	Water pressure too high (no beeps).	Reduce pressure to under 80 PSI.
Faucet turns on by itself	Incorrect range setting for spout type and	Change range setting using DIPswitch (page 6).
(ghosting).	sink used (2 beeps).
No water flow.	Water not turned on (no beeps).	Turn on water supply.
	Solenoid cable not connected to	Check connection.
	electronics cover (5 beeps).
	Solenoid short circuit (4 beeps).	Replace electronics cover.
	Sensor cable not connected to electronics	Check connection.
	cover (no beeps).
	Inoperative sensor (no beeps).	Inspect collar wiring for signs of damage or corrosion.
		Replace if necessary.
	Inoperative electronics cover assembly	Replace cover assembly.
	(no beeps).
	Water pressure too high (no beeps).	Reduce pressure to under 80 PSI.
	Low battery voltage (DC only) (1 beep).	Replace batteries (DC only).
	6VDC transformer not properly connected	Use correctly sized terminal clips (page 4).
	to partition assembly (no beeps).
	Wiring of multiple unit 6VDC transformer	Faucets must be wired in parallel from transformer
	(no beeps).	(transformer to each individual unit), not connected in
		a series.
Range too short or too long.	Interference during automatic calibration	Remove interference; reset electronics using reset
	(no beeps).	button (page 6). Allow 30 seconds for faucet to
		automatically re-calibrate.
	Incorrect range setting for type of spout	Change range setting using DIPswitch (page 6).
	and sink used.
	Lighting environment affecting sensor	Change range setting using DIPswitch (page 6).
	(3 beeps).

Bradley Corporation • 215-1559 Rev. A; EN 04-216A 9/23/04 7