3Com 3CB9LF20R, 3CB9LF36RL, 3CB9LF36TL, 3CB9LG9MC, 3CB9LF20MM Compliance, 3Com Year 2000 Web

Page 54

54CHAPTER 5: REFERENCE

If a Gigabit Ethernet switching module port has autonegotiation enabled with the port enabled, but the remote end of the connection has autonegotiation enabled with the port disabled, the enabled port goes on-line and the port LED lights green. The disabled port stays off-line.

To avoid such problems, 3Com recommends that you always set the connected port pairs to the same mode, in one of the following ways:

Enable autonegotiation at both ends of the connection.

Disable autonegotiation at both ends of the connection and statically configure each endpoint identically.

Either way prevents mismatches and the associated errors.

Year 2000

For information on Year 2000 compliance and 3Com products, visit the

Compliance

3Com Year 2000 Web page:

 

http://www.3com.com/products/yr2000.html

Image 54
Contents CoreBuilder Release Notes 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Contents Release Issues Software Installation Page Overview Management Information Bases MIBs Requirements Boot CodeSystem Operational CodeRedundancy 3CB9LG9MCRelease Highlights IgmpManagement CoreBuilder 9000 Enterprise SwitchWeb-based Software CDISO Date and Time FormatNew Modules 10/100 Mbps Ethernet Port Monitoring QueryingSnooping 802.1p CoS Loop DetectionCoreBuilder 9000 Implementation Guide for more details Release Highlights LoopDetectMode loopDetectSrcAddress Enable 08-00-8f-75-48-86 LoopDetectStatus Bridge Address Learning LimitsAddresses Addresses are taken from the per-port address allocations Learning ModeSecure Address See the previous section Bridge Address Learning LimitsSecure Address Learning Mode Vlan Flood Rate Limiting BroadcastMulticast, Vlan as the arriving packetMulticastlimit Limiting is on a per-port basis only Release Highlights System Release IssuesCorrected Problems ManagementWhenever a non-switch fabric module is reset with VLANs StagingWeb-based System Issues Module Modules have only one backplane portModel Number 3CB9LF36RL or 3CB9LF36TL to act as an Igmp TrunkingSystem Issues Release Issues Known Problems Release Issues Known Problems Not reset after you enter the module baseline set command Administration Console of the 36-port 10/100BASE-TX FastModify command If a trunk is configured on a module, the following fieldsKnown Problems Documentation ChangesDocumentation Software Installation Chassis At the EME prompt, enterVerifying Your module for guidelines and proceduresOrder specified in the following procedure ModulesSoftware next in this chapter Power to these module slotsFollowing procedure explains how to download software ModulesShow module slot.all verbose From the EME, connect to the module You must complete to ensure that the module is updated Downgrading Switching Modules to Software Release Identifying SwitchReference Modules3CB9LG2MC MIB Files Applicable Documents CoreBuilder 9000 Implementation GuideReference Entering Commands UnderstandingAutonegotiation Year Compliance3Com Year 2000 Web Technical Support ServicesServices Online TechnicalAccess by Analog Modem Username anonymousModem Isdn 24 hours a day, 7 days a week Access by Digital Modem 847 262408 727 Europe Country Telephone Number North America