24CHAPTER 2: RELEASE HIGHLIGHTS
Example:
CB9000@slot 5.1
Menu options (CoreBuilder
igmp - Administer IGMP snooping
multicastLimit - Set the multicast packet rate limit broadcastLimit - Set the broadcast packet rate limit floodLimit - Set the flood packet rate limit CB9000@slot 5.1
multicastlimit
Enter new value
This example limits the total multicast traffic leaving participating
3Activate (or deactivate) multicast limiting.
■To activate multicast rate limiting (to turn limiting on), enter
McastBcast
■To deactivate multicast rate limiting (to turn limiting off), enter
BcastOnly
4From the bridge port menu, enter the particular packet type, to configure each port to participate in either broadcast or flood module rate limiting (in addition to multicast rate limiting, which you configured in Step 3).
■To activate broadcast or
■To deactivate broadcast or
Example (broadcast rate limiting):
CB9000@slot 5.1
broadcastLimitMode
Select bridge ports
Enter new value (disabled,enabled) [disabled]:
If you select disabled for a port, the port does not participate in the module broadcast rate limiting.
The following example illustrates what happens when, for example, you specify an egress threshold of 3,000 fps for the module’s multicast rate limit. Ports 3 and 10 are configured to participate in module multicast rate limiting.