11 INSTALL HANDLES
LEVER HANDLE
Turn HANDLE STEM (1) to "OFF" position.
Place the HANDLE ADAPTER (2) on the HANDLE STEM (1). Install the ADAPTER SCREW (3) and tighten securely.
Position LEVER HANDLE (4) and place on ADAPTER (2). Install the HANDLE SCREW (5) and tighten securely.
4
5
3
2
1
12 TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.
Operate both HANDLES (1) to flush water lines thoroughly.
Rotate TRANSFER VALVE (5) from rim wash to spray several times to check operation.
OUTLINE OF BIDET | 1 |
|
3
1
13 CHECK DRAIN CONNECTIONS |
|
|
Pull up | 4 |
|
that DRAIN STOPPER (4) makes a good seal and retains | 2 | |
water in Bidet. If STOPPER (4) does not seal properly, |
| |
|
|
please refer to “Troubleshooting Guide” in these instructions. | SPRAY |
| |
Push |
|
connections and "P" trap for leaks. Tighten |
|
if necessary. |
|
2
14 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
15 | SERVICE |
|
| |
To change direction of handle |
|
| ||
| rotation, proceed as follows: |
|
| |
Turn VALVE to OFF position. | 1 |
| ||
Loosen HANDLE SCREW (1) . |
| 2 | ||
Pull HANDLE (2) off ADAPTER (4). Loosen | ADAPTER | 3 | ||
SCREW (3) and pull off ADAPTER (4). |
| |||
Remove SPRING CLIP (7). Lift STOP WASHER (5), |
| |||
turn 90° and replace. Replace SPRING CLIP (7). | 4 | |||
Reinstall ADAPTER SCREW (4) and LEVER HANDLE (2). | ||||
| ||||
Tighten HANDLE SCREW (1). |
| 90˚ | ||
If spout drips, operate handles several |
| 5 | ||
| 6 | |||
times from OFF to ON position. Do not |
| |||
force - handles turn only 90˚.
7
M 9 6 8 6 7 7 R e v . 1 . 1
4