American Standard 3475.5 installation instructions Fig. G, Locked Mode Vandal Proof Unlocked Mode

Page 6

STOPPER INSTALLATION PROCEDURE

The Stopper can be installed two ways, “Locked” Mode (Stopper cannot be removed) or “Unlock” Mode (Stopper is removable).

Locked Mode:

Look at the Plastic Loop at the bottom of the Stopper and notice that the Loop is on one side of the Stopper. Fig. G.

To install the stopper in “Locked” mode, insert the Stopper into the Drain so that the Plastic Loop is facing toward the rear of the Sink and the American Standard logo is facing front. Rotate

Stopper slightly if necessary so that the Stopper slides all the way down.Fig. G.

Re-install the Cam into the Drain, rotating the Cam if necessary to make sure it is fully inserted. Fig. J.

Re-install the Cam Cap, making sure the guide teeth are facing outward. If the Cam Cap does not “snap” into place, then rotate the Cam to make sure it is fully inserted. Fig. K.

Re-attach Cable. See “CABLE ADJUSTMENT PROCEDURE” in Troubling Shooting Guide to complete installation. Stopper will be in “Locked” mode and not be removable.

Fig. G.

LOGO

LOOP TOWARD

REAR OF BIDET

DRAIN

Locked Mode

(Vandal Proof)

Unlocked Mode:

Look at the Plastic Loop at the bottom of the Stopper and notice that the Loop is on one side of the Stopper. Fig. H.

To install the stopper in “Unlocked” mode, insert the Stopper into the Drain so that the Plastic Loop is facing toward the front of the

Sink and the American Standard logo is facing rear. Rotate Stopper slightly if necessary so that the Stopper slides all the way down.

Fig. H.

Re-install the Cam into the Drain, rotating the Cam if necessary to make sure it is fully inserted. Fig. J.

Re-install the Cam Cap, making sure the guide teeth are facing outward. If the Cam Cap does not “snap” into place, then rotate the Cam to make sure it is fully inserted. Fig. K.

Re-attach Cable. See “CABLE ADJUSTMENT PROCEDURE” in “Troublingshooting Guide” to complete installation. Stopper will be in “Unlocked” mode and removable.

Fig. H.

LOGO

180˚

LOOP TOWARD

FRONT OF BIDET

DRAIN

Unlocked Mode

Fig. J.

CAM

Fig. K.

INSTALL CAM

INSTALL CAM CAP

M 9 6 8 6 7 7 R e v . 1 . 1

6

Image 6
Contents Bidet Faucet Installation Spray InstallationBidet Faucet and Transfer Valve With Speed Connect Drain POP-UP Drain Install Drain from Tighten Locknut Below FixturePOP-UP ROD Assembly Remove FlangeAttach Cable ConnectorInstall Diverter Knob Check Operation of POP-UPInstall Handles Test Installed FittingCheck Drain Connections Troubleshooting Guide Cable Adjustment ProcedureLocked Mode Vandal Proof Unlocked Mode Fig. G3475.501 Bidet Faucet and Transfer ValveInstall Drain from Attach Cable Connector EverClean Finish Care Instructions SpeedConnect Drain Locked Mode Vandal Proof Unlocked Mode