American Standard 621.001 installation instructions Countertop Installation

INSTALLATION INSTRUCTIONS

CARE AND MAINTENANCE

ABOVE COUNTER SINK FOR USE WITH: 0621.001 STUDIO

Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.

!CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

RECOMMENDED FAUCET*: 2064.101 ONE lavatory faucet

*Log on to www.americanstandard-us.com for additional faucet selections.

RECOMMENDED TOOLS AND MATERIALS

Putty Knife	Regular Screwdriver	Adjustable Wrench	Channel Lock Pliers	Jig Saw
Hacksaw	Phillips Screwdriver	Pipe Wrench	Basin Wrench	Drill
Tubing Cutter	Tape Measure	Silicone Adhesive	Plumber’s Putty or Caulking

OBSERVE LOCAL PLUMBING AND BUILDING CODES

COUNTERTOP INSTALLATION

1	Using the template provided, locate the position of the sink		5
	on the countertop. Provide proper clearance under the
	countertop for the faucet supply lines, drain assembly and		After checking fit		E
	the structural parts of the cabinet.
			and alignment,		S
	NOTE: If replacing an existing sink be certain to shut off
			turn sink upside
	water supply before removing old sink.
			down and apply a		U
2	Drill a clearance hole inside the perimeter line of the		generous portion
	template for countertop installation.		of silicone
			adhesive around		E
	Perimeter	Perimeter of	the under side of
		template	the rim near the		R
	of
	template		edge. Place sink in		U
			position. Wipe off
			excess adhesive.		T
					U
	Cut opening around the perimeter of the template.		6	Mounting holes are provided on the rear of the	F
				lavatory so it can be secured to the wall if desired.

3

Mount the faucet and drain			R
		7	O
assembly (not included) on
the sink following the			F
manufacturer’s instructions.		Connect supply line to
Be certain to apply a bead	A
		faucet (finger tight) and
of sealing putty on the
		carefully bend tubes to	E
underside of the drain (Part
		engage with the supply
“A”) in order to ensure a
		shut-off valves. Tighten	V
watertight seal between the
		connections at faucet
sink and drain. Remove			A
		and shut-off valves for
excess putty after installing
		secure seal.
drain on sink.			S
4		Shut-Off Valves
		8
		Connect trap to drain
		assembly hand tight to
		check alignment. It may
		be necessary to cut off	C
		part of the tailpiece (area
		“B”) or part of the	B
• Place the sink temporarily into the template.		horizontal leg of the trap
		(area “C”). Secure joints
• Check for alignment and clearance.		for watertight assembly.

•Mark the sink and countertop in several places as a guide for the installation location.

P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c . © A S A m e r i c a , I n c . 2 0 0 9

7301244-100 Rev. A