| Installation |
| Instructions |
PORTSMOUTH™ | 7420.101 |
MONOBLOCK LAVATORY | 7415.101 |
FAUCET with Speed Connect™ Drain Series
Congratulations on purchasing your American Standard faucet with Speed Connect drain, a feature found only on American Standard faucets.
Speed Connect Drain*
•Fewer parts, installs in less time
•Never needs adjustment
•Guaranteed to seal properly the first time, every time.
7415.101
7420.101
Certified to comply with ANSI A112.18.1
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
To ensure that your installation proceeds
Recommended tools
|
| Screwdriver |
| Channel Locks | Adjustable Wrench | |
|
|
|
|
|
|
|
| 1 | INSTALL FAUCET |
|
| Turn off hot and cold water |
|
|
| CAUTION |
| |||
|
| supplies before beginning. |
| |||
| 7420.101 & 7415.101 |
|
|
|
| |
Installation with ESCUTCHEON PLATE: Apply a light bead of plumbers putty
to underside of ESCUTCHEON PLATE (8) if mounting surface is uneven. Place ESCUTCHEON PLATE (8) onto sink or mounting surface. Feed FAUCET SUPPLIES (3), MOUNTING
STUD (4) and DRAIN CABLE ASSEMBLY (8) through ESCUTCHEON PLATE (8) and mounting hole of lavatory or mounting surface. Fig. A.
Installation less ESCUTCHEON PLATE:
Seat SEAL (1) into under side of FAUCET BASE (2).
Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and DRAIN |
| Fig. A. |
| |
CABLE ASSEMBLY (8) through the mounting hole of lavatory or |
|
|
| |
mounting surface. Fig. B. |
|
| 8 |
|
|
|
|
| |
|
|
| 1 |
|
|
|
| 2 |
|
|
| 1 | GROOVE |
|
|
|
| (FAUCET | PUTTY |
|
|
| BASE) | |
| 7 | 3 |
| IF REQUIRED |
| 4 |
| ||
| Fig. B. |
| ||
| 5 |
|
| |
| 6 |
|
|
|
COLLAR ON | 4 |
| MOUNTING SURFACE | |
MOUNTING NUT |
| |||
|
|
|
| |
| Fig. C. |
|
|
|
From below, push GASKET (7) and RETAINING WASHER (5) onto |
|
|
| |
MOUNTING STUD (4). Secure Faucet with MOUNTING NUT (6), |
|
|
| |
pulling faucet to front of sink, so SUPPLIES (3) rests against |
|
|
| |
mounting hole. Before final tightening, make sure collar on |
|
|
| |
MOUNTING NUT (6) is seated into RETAINING WASHER (5). |
|
|
| |
Fig. C . |
|
| 8 |
|
Adjust Faucet so that it is centered. Tighten MOUNTING NUT (6) to complete faucet mounting.
1