American Standard 7420.101, 7415.101 Attach Cable Connector, Check Operation of POP-UP

7	ATTACH CABLE CONNECTOR
		Fig. A.		Fig. B.
	Thread CABLE CONNECTOR (1) clockwise
	onto DRAIN BODY CONNECTION (2) and		1
	hand tighten. Fig. A.

Your new POP-UP DRAIN installation is now complete. Fig. B.

Note: Tailpeice on pop-up drain is 1-1/4” O.D.

Fig. B.

		2	1-1/4” O.D.
8	CHECK OPERATION OF POP-UP
	Operate LIFT KNOB (1) to verify that STOPPER (2) opens and	1
	closes.
	Note: If STOPPER (2) does not open and close properly then
	refer to the “troubleshooting section” of these instructions.

2

9 MAKE WATER SUPPLY AND WASTE CONNECTIONS

Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left SUPPLY (1) to Hot (Marked with a Red Band) and right supply to COLD (2) wall supply.

Faucet supplies are 20" long from faucet base.

Note: If additional supply length is required, installer must purchase additional parts separately.

Important: If SUPPLY HOSES (1, 2) are to long, loop as
illustrated to avoid kinking.
Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to	APPROX. 20"
waste outlet.

1

2

BLUE

REDBAND BAND

3/8" COMPRESSION

HOT COLD

M965016 REV.1.6

3