American Standard 7415.101, 7420.101 POP-UP Drain, Remove Flange, Flange Gasket and POP-UP Knob

2 POP-UP DRAIN	Fig. A.	Fig. B.
Remove CLEAR PLASTIC COVER (1).	1
Remove CARDBOARD SPACER (2) from under	3	DRAIN
DRAIN POP-UP (3).
		BODY
Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY. Fig. B.
	2	4

3 REMOVE FLANGE	Fig. A.		Fig. B.
Thread FLANGE (1) counter-clockwise and remove	1
FLANGE (1) and FOAM GASKET (2) from drain
body. Fig. A.
Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against			4
LOCKNUT (3). Fig. B.		2

3

4	INSTALL DRAIN FROM		5 TIGHTEN LOCKNUT
	BELOW FIXTURE	REAR
	From under side of SINK	OF SINK	Tighten LOCKNUT (1) firmly with Adjustable
	install DRAIN BODY (1) up	4	Wrench or Channel Locks.
	through drain outlet.
	Note: No plumber’s putty	DRAIN
	or caulk is required.	OUTLET
		3
	The CABLE ATTACHMENT
	POINT (2) must face towards
	the rear of the SINK.		1
	Install FOAM GASKET (3) and	1
	FLANGE (4) onto drain body	2
	from above SINK and tighten
	FLANGE (4) firmly.

6		FLANGE GASKET AND POP-UP KNOB
			Fig. A.			Fig. B.	DOWN
		Check DRAIN FLANGE in SINK to ensure that
		WHITE FOAM GASKET (3) is fully compressed
		and not visible. Fig. A.						1
	POP-UP KNOB (1) must be fully down. Fig. B.
				WHITE FOAM	DRAIN
				GASKET
				NOT VISIBLE	FLANGE

M965016 REV.1.6

2