American Standard 7415.101 Test Installed Fitting, Check Drain Connections, Service Caution

M965016 REV.1.6

ON

10 TEST INSTALLED FITTING

With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3).

Operate HANDLE (1) to flush water lines thoroughly.

Replace AERATOR (3).

CHECK DRAIN CONNECTIONS

Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK. If DRAIN STOPPER (5) does not seal properly, please refer to Troubleshooting section in these instructions.

Release POP-UP KNOB (4) down and check all drain connections and "P" trap for leaks. Tighten

if necessary.

4

WASTE

OUTLET

OFF

1 COLD

HOT

3

5

				2
			2	“P” TRAP
11 SERVICE CAUTION	Turn off hot and cold water			3
	supplies before beginning.
To remove or replace cartidge: Fig. A.			2.5mm HEX KEY	2
Turn valve to OFF position.
Remove HANDLE SCREW (2).				4
Pull off HANDLE (3) and CAP (4).			Fig. A.
Unthread CARTRIDGE NUT (5) and remove.
Pull out CARTEIDGE (6).			REMOVE	INSTALL
Inspect CARTRIDGE (6) and O-RING (7) for debris and clean
if necessary.				5
Clean MANIFOLD (8) and rinse clean.
Reinstall CARTRIDGE (6) and O-RING (7) onto MANIFLOD (8).
Reinstall CARTRIDGE NUT (5), CAP (4) and HANDLE ASSEMBLY (3).
If spout drips, operate handle several times from OFF to ON and HOT to
COLD position. Do not force - handles turn only 90˚.				6
7420.101 ONLY. SPOUT CAN BE FIXED OR SWIVEL.
CONVERT TO A FIXED SPOUT IF DESIRED. Fig. B.				7
To change from swivel to fixed spout, proceed as follows:
Remove SET SCREW (1) using Hex Wrench supplied. VIEW “A”				8
Install FIXING SET SCREW (2) using Hex Wrench supplied.		3
Align SPOUT (3) and tighten SET SCREW (2) to secure
SPOUT (3).	2

	VIEW "A"	1
3		Fig. B.

12 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

4