Craftsman 139.53978SRT owner manual Tighten Chain, = Lo Tro,.y

Page 11

Assembly

Step 5

I

 

Tighten the

Chain

 

•Spin the inner nut and lock washer down the threaded shaft, away from the trolley.

•To tighten the chain, turn outer nut in the direction shown (Figure 1).

•When the chain is approximately 1/2" above the base of the rail at its midpoint, re-tighten the inner nut to secure the adjustment.

Sprocket noise can result if chain is too loose.

When installation is complete, you may notice some chain droop with the door closed. This is normal. If the chain returns to the position shown in Figure 2 when the door is open, do notre-adjust the chain.

NOT_. During future maintenance, AL WA YS pull the emergency release handle to disconnect trolley before adjusting chain.

NOTE: You may notice loosening of chain after Adjustment Step 4 (Test the Safety Reverse System). Check for proper tension and readjust chain ff necessary. Then repeat Adjustment Step 4.

Figure I

o=_ Lo_ Tro,.y

Nut Washer Shaft

ToT_.,_nOuterNut.--_ I ! /

Inner Nut

Figure 2

Chain

I

 

 

 

r

 

 

--..L..L .LLLJ_

J--L_--L L_L_J_ _

 

i

I1/_ Inch

 

I

 

Base o Ra

Mid tength of Rail

You have now finished assembling your garage door opener. Please read the following warnings before proceeding to the installation section:

IMPORTANT INSTALLATION INSTRUCTIONS

To reduce the risk of severe injury or death to persons:

1.READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.

2.Install only on a properly balanced and lubricated garage door. An Improperly balanced door may not reverse and could result in severe injury or death. Repairs to cables, spring assemblies and other hardware must be made by a professional service person before installing opener.

3.Disable all locks and remove all ropes connected to the garage door before installing the opener.

Ropes connected to a garage door can cause entanglement and death.

4.If possible, install door opener 7 feet or more above floor with the emergency release handle mounted 6 feet above the floor.

5.Do not connect the opener to power source until instructed to do so.

6.Locate the Door Control within sight of the door at a minimum height of 5 feet where small children cannot reach and away from all moving parts of the door.

7.Install the User Safety Instruction Label on the wall adjacent to the door control and the Maintenance Instruction Label in a prominent location on the inside of the garage door.

8.Upon completion of the installation, the door must reverse when it comes in contact with a one-inch high object or a 2x4 laid flat on the floor.

9.Do not wear watches, rings or loose clothing while installing or servicing an opener. Jewelry or loose clothing can be caught in the mechanism of the garage door or the opener,

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Garage Door Opener Instructions. Read the instructions carefully Start by reviewing these important safety alert symbolsYoull Need Tools Closed Position SafetyBased on your particular requirements, there are Closed Position One-Piece Door with TrackOne-Piece Door without Track Section Carton Inventory@ @ Safety Reversing SensorAssembly Step Assembly Section Pages 8Hardware Shown Actual Size Install the Idler PulleyFasten the Rail to the Opener Master Link Clip-OnSpdng Unk Cap Install the Chain/Cable Attach the Sprocket Cover= Lo Tro,.y Tighten ChainProceed to , Installation Section Pages 12 Installation StepDetermine Header Bracket Location Example One-piece door without track Jamb hardwareCeiling Header Bracket Installation Install the Header BracketWall Header Bracket Installation Insert a ring fastener to secure Attach the Rail to the Header BracketWith the door fully open and parallel to the floor Position the OpenerHang the Opener Installation StepShown Actual Size UihJIlnJIlilililil Ililn Install the Door ControlSlide down to secure. Adjust screw for snug fit Serious injury or deathAttach the Emergency Release Rope and Handle Install the Light and the LensInstall the light Install the lensRightWrong Permanent Widng ConnectionsElectrical Requirements Important Information about Safety Reversing Sensor Safety Reversing SystemGarage door track installation preferred Sensor Safety ReversingInstalling the Brackets Be sure power to the opener is disconnectedTrouble Shooting the Safety Sensors Mounting and Wiring the Safety SensorsAligning the Safety Sensors Fasten Door Bracket IIIIIlllillllILllllllllllllllllNut IIIIIII11111111LLLIIIIIlIAbove holes Connect Door Arm to TrolleyRBok Adjustment Procedures for One-Piece Doors Adjustment Step If the door does not close completely Adjustment Section Pages 28 Adjustment StepHow and When to Adjust the Limits Adjust the UP and Down LimitsHow and When to Adjust the Forces Adjust the ForcePress the remote control push button to open the door Test The Safety Reversing SensorTest the Safety Reverse System Important safety checkSchedule MaintenanceTo reduce the risk of severe injury or death to persons Manual disconnect Position Operation of Your OpenerOperation of the Door Control see SECURITY,I Receiver and Remote Control ProgrammingIf you have a Premium Control Console If you do not have a Premium Control ConsoleSituation Probable Cause and Solution Having a Problem?Doesnt turn off Situation Probable Cause SolutionDoor opens but Opener lights blink for 5 secondsInstallation Parts Repair PartsRail Assembly Parts Br co.tact ASSEMe,v Opener Assembly PartsWith the door closed AccessoriesOnly through Sears Parts & Service For Sectional Doors OnlIndex Para ordenar piezas con entrega a domicilio For in-homemajor brand repair serviceSears Warranty

139.53978SRT specifications

The Craftsman 139.53978SRT is an advanced garage door opener that combines reliability, performance, and ease of use. Designed to cater to the needs of modern homeowners, this model stands out with its robust features and technological innovations.

One of the key highlights of the Craftsman 139.53978SRT is its powerful motor, delivering a peak horsepower equivalent to ensure smooth and efficient operation. This allows it to effortlessly lift even the heaviest of garage doors, making it suitable for various types of residential garage doors. The quiet operation of this opener is another major advantage, allowing for a peaceful environment in and around the garage.

Another notable feature is the smart technology integration. The Craftsman 139.53978SRT is compatible with a range of smart home systems, allowing users to control their garage door remotely via a smartphone app. This feature not only adds convenience but also enhances security, as users can receive alerts and notifications about the status of their garage door, ensuring peace of mind.

Security is a priority with this model, which comes equipped with rolling code technology. This mechanism generates a new code each time the remote is used, preventing unauthorized access and ensuring that your garage remains secure from intruders. Additionally, the enhanced safety features include safety sensors that detect obstacles, automatically reversing the door's movement if something is detected, thereby preventing accidents.

Installation and setup are straightforward, thanks to the user-friendly design of the Craftsman 139.53978SRT. The unit includes detailed instructions and all necessary hardware for installation. Many users can set it up within a few hours without the need for professional assistance.

With a durable construction, the Craftsman 139.53978SRT is built to last. It has a sleek design that complements various home aesthetics while withstanding wear and tear from daily use. Maintenance is minimal, with easy access to essential components for servicing.

In summary, the Craftsman 139.53978SRT offers a perfect blend of power, technology, and security features. Its user-friendly design, combined with smart technology compatibility and robust safety measures, makes it an ideal choice for homeowners seeking a reliable garage door opener. Whether you’re looking to upgrade an old system or install a new one, this model is sure to meet your requirements and enhance the functionality of your garage.
Top Page Image Contents