Craftsman 139.53515SR - I/2HP Safety Reverse System Test is Very, EEP Garage, Not, Them, Clothing

Page 2

Start By Reading These Important Safety Rules

THIS SAFETY ALERT SYMBOL MEANS CAUTION --PERSONAL SAFETY OR PROPERTY

DAMAGE INSTRUCTION, READ THESE INSTRUCTIONS CAREFULLY.

THIS GARAGE DOOR OPENER IS DESIGNED AND TESTED TO OFFER REASONABLY SAFE SERVICE PROVIDED IT IS INSTALLED AND OPERATED IN STRICT ACCORDANCE

WITH THE FOLLOWING SAFETY INSTRUCTIONS.

FAILURE TO COMPLY WITH THE FOLLOWING INSTRUCTIONS MAY RESULT IN SERIOUS, PERSONAL INJURY OR PROPERTY DAMAGE.

CAUTION: IF YOUR GARAGE HAS NO SERVICE ENTRANCE DOOR, INSTALL MODEL 53702 EMERGENCY RELEASE

KEYLOCK (PAGE 4). THIS ACCESSORY ALLOWS MANUAL OPERA TION OF GARAGE DOOR FROM OUTSIDE IN CASE OF POWER FAILURE.

 

 

 

 

 

 

 

 

 

THE SAFETY REVERSE SYSTEM TEST IS VERY

A

binding

doors must be repaired. Garage doors,

J_.

IMPORTANT (page

18). Your garage door MUST

EEP GARAGE

DOOR BALANCED. Sticking or

reverse

on contact

with a 1" obstacle placed on

 

door swings, cables, pulleys, brackets

and their

 

 

hardware are under extreme tension and can

 

the floor. Failure to properly adjust the opener

 

cause

serious

personal

injury.

DO

NOT

 

 

 

may result

in serious personal injury from a

 

ATTEMPT

TO

LOOSEN,

MOVE OR

ADJUST

 

closing

garage door. REPEAT THE TEST AT

 

THEM.

Call s garage door

serviceman.

 

 

LEAST ONCE EVERY THREE MONTHS AND

 

 

 

 

 

 

 

 

 

MAKE

NEEDED ADJUSTMENTS.

 

DO NOT WEAR RINGS, WATCHES OR LOOSE

 

Fasten

the CAUTION LABEL alongside the Wall

 

CLOTHING

while installing

or servicing

a garage

 

 

door opener.

 

 

 

 

 

Control as a reminder of safe operating

 

 

 

 

 

 

procedures.

 

 

 

To avoid serious

personal

injury from entangle-

 

Install

the

Wall Control (or any additional push

 

ment, REMOVE ALL ROPES CONNECTED

TO

 

buttons) IN A LOCATION WHERE THE GARAGE

THE GARAGE DOOR before installing the garage door opener.

DOOR IS VISIBLE, BUT OUT OF THE REACH OF CHILDREN. DO NOT ALLOW CHILDREN TO

OPERATE THE WALL PUSH BUTTON(S) OR TRANSMITTER. Serious personal injury from a

DISENGAGE ALL EXISTING GARAGE DOOR LOCKS to avoid damage to garage door.

Installation and wiring must be in compliance with your local building and electrical codes.

CONNECT THE POWER CORD ONLY TO A

PROPERLY GROUNDED OUTLET.

LIGHTWEIGHT FIBERGLASS, ALUMINUM AND STEEL DOORS MUST BE SUBSTANTIALLY

REINFORCED TO AVOID DOOR DAMAGE. (See page 15.) The best solution is to check with your

garage door manufacturer for an opener installation reinforcement kit.

DO NOT USE THE FORCE ADJUSTMENTS TO COMPENSATE FOR A BINDING OR STICKING GARAGE DOOR. Excessive force will interfere with the proper operation of the safety reverse system or damage the garage door (page 17).

closing garage door may result from misuse of the opener.

CAUTION: Activate opener only when the door is in full view, free of obstructions end opener

is properly edjusted. NO ONE SHOULD ENTER OR LEAVE THE GARAGE WHILE DOOR IS IN

MOTION. DO NOT ALLOW CHILDREN TO PLAY NEAR THE DOOR.

Use the emergency release ONLY to disengage the trolley and, if possible, ONLY when the door is closed. DO NOT USE EMERGENCY HANDLE TO PULL DOOR OPEN OR CLOSED.

DISCONNECT ELECTRIC POWER TO GARAGE DOOR OPENER BEFORE MAKING REPAIRS OR REMOVING COVERS.

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Contents Model 139.53626SR I/2HP Model 139.53515SR I/2HPMake Needed Adjustments Do not Wear RINGS, Watches or Loose Safety Reverse System Test is VeryAttempt Loosen Move or Adjust EEP GarageCare of the Opener Accessories Features of Your OpenerSpecifications Assembly Hardware Installation Youll Need ToolsCablepulleybracket AttachestoFRONT ENDofteerail AssemblyAssemble Tee Rail & Attach Cable Pulley Bracket CarefullyLockWasher Slide trolley assembly along rail to screwdriver stopAttach Tee Rail To Opener Chassis LodAttach Sprocket Cover to Chassis Install Chain and CableRemove Screwdriver Step Tighten the Chain and CableInstallation Sectional Door Piece Door with Track InstallationInstallation Piece Door Without Track ExampleAttach Tee Rail to Header Bracket Installation Sectional & ONE-PIECE Door with TrackInstallation ONE-PIECE Door With no Track Position Opener ChassisAttach Emergency Release Rope & Handle 16LockWasher 5/16-18NutWiring Instructions for Accessories Lock FeatureLight Feature Operation of Wall Control Wall Controlpush BARInstalling Lens Install Lights and LensesConnect Electric Power Permanent Wiring ConnectionDoor--HeaderWall Bracket OnepiecedoorLine Adjustment Procedures Sectional Door InstallationONE-PIECE Door Installation Connect Door Arm to TrolleyLimit Adjustment Chart AdjustmentAdjust UP and Down Limits Force Adjustment ChartOptional Instafl Infrared Reversing Sensor Test Safety Reverse SystemRepeat Adjustment After MATCH/CHANGE the Code in Transmitters SET Code Switches in ALL Transmitters to Matching PositionsSeries with Receiver Code Switches SET Receiver to MatchSituation Having a Problem?Probable Cause & Solution Door Wont CloseDo not Turn on Unit Must be GroundedKEY Part Repair PartsInstallation Parts List DescriptionNot Shown DriveWire Gear Contact Contact WireKEY Part NO. NO. Description Oown139.53626SR Sears WarrantyHOW to Order Repair Parts

139.53626SR - I/2HP, 139.53515SR - I/2HP specifications

The Craftsman 139.53626SR and 139.53515SR are two remarkable garage door openers that deliver reliable performance and advanced features ideal for both residential and commercial applications. Both models are powered by a robust ½ horsepower motor, providing a strong lift capability that can handle various types of garage doors.

One of the main features of the Craftsman 139.53626SR is its quiet operation. Designed with a belt drive system, it minimizes noise while delivering consistent performance. This makes it an excellent choice for homes where the garage is attached to the living space. The unit is also equipped with a soft-start and soft-stop feature, which ensures gentle movement of the door, further reducing noise and extending the lifespan of the garage door system.

The Craftsman 139.53515SR, on the other hand, incorporates a chain drive mechanism which is known for its durability and strength. This model is perfect for heavier doors or commercial applications where durability is crucial. It is built to withstand the rigors of frequent use and features a robust frame designed for long-lasting performance.

Both models include advanced safety features such as the infrared safety sensors that prevent the door from closing if something is detected in its path, thereby reducing the risk of accidents. They also come with a multi-function wall console, allowing for easy operation and access to settings like the vacation lock and door light control.

In terms of technology, the Craftsman openers are equipped with a security code system that changes the access code each time the remote is used. This feature enhances security by minimizing the risk of unauthorized access. Furthermore, both models are compatible with smartphone control options when paired with additional Craftsman connectivity accessories, providing users with the convenience of operating their garage doors remotely.

Setting up the Craftsman 139.53626SR and 139.53515SR is straightforward, thanks to the included installation manuals and clear instructions. Both models are designed for easy installation, making them ideal for DIY enthusiasts.

Overall, whether you choose the 139.53626SR for its quiet performance or the rugged 139.53515SR for its strength, both Craftsman garage door openers deliver reliability, advanced features, and safety, making them excellent additions to any home or business.
Top Page Image Contents