Frigidaire FRA103KT1 important safety instructions Before You Call, Occurrence Solution

Before You Call

Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

OCCURRENCE	SOLUTION
Air conditioner will not operate.	Wall plug disconnected. Push plug firmly into wall outlet.
	Plug Current Device Tripped. Press the RESET button.
	House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker.
	Control is OFF. Turn Control ON and set to desired setting.
Air from unit does not feel cold	Room temperature below 60°F (16°C). Cooling may not occur until room temperature rises above
enough.	60°F (16°C).
	Temperature sensing element touching cold coil, located behind air filter. Straighten away from coil.
	Reset to a lower temperature.
	Compressor shut-off by changing modes. Wait approximately 3 minutes and listen for compressor to
	restart when set in the COOL mode.
Air conditioner cooling, but room	Outdoor temperature below 60 O F (16 OC). To defrost the coil, set FAN ONLY mode.
is too warm - ice forming
	Air filter may be dirty. Clean filter. Refer to Care and Cleaning section. To defrost, set to FAN ONLY
on cooling coil behind decorative
	mode.
front
	Temperature is set too low for night-time cooling. To defrost the coil, set to FAN ONLY mode. Then,
	set temperature to a higher setting.
Air conditioner cooling, but room	Dirty air filter - air restricted. Clean air filter. Refer to Care and Cleaning section.
is too warm - NO ice forming on
	Temperature is set too high. Set temperature to a lower setting.
cooling coil behind decorative
	Air directional louvers positioned improperly. Position louvers for better air distribution.
front.
	Front of unit is blocked by drapes, blinds, furniture, etc. - restricts air distribution. Clear blockage in
	front of unit.
	Doors, windows, registers, etc. open - cool air escapes. Close doors, windows, registers, etc.
	Unit recently turned on in hot room. Allow additional time to remove “stored heat” from walls, ceiling,
	floor and furniture.
Air conditioner turns on and off	Dirty air filter - air restricted. Clean air filter.
rapidly.
	Outside temperature extremely hot. Set FAN speed to a faster setting to bring air through cooling coils
	more frequently.
Noise when unit is cooling.	Air movement sound. This is normal. If too loud, set to lower FAN setting.
	Window vibration - poor installation. Refer to installation instructions or check with installer.
Water dripping INSIDE when	Improper installation. Tilt air conditioner slightly to the outside to allow water drainage. Refer to
unit is cooling.	installation instructions or check with installer.
Water dripping OUTSIDE when	Unit removing large quantity of moisture from humid room. This is normal during excessively humid
unit is cooling.
	days.
Room too cold.	Set temperature too low. lncrease set temperature.

If These Solutions Fail, Call 1-800-944-9044 For Frigidaire Service.

2009 Electrolux Home Products, Inc. All rights reserved. 11