OPERATING PROCEDURE | PHOTOS |
3. Removing the electrical box | Photo 5 |
(1)Remove the panel (Refer to 1.) and the corner box.
(2)Remove the indoor/outdoor connecting wire, the sensor holder, the electrical cover and the ground wire. (Refer to 2.)
(3)Disconnect the following connectors on the electronic con- trol P.C. board;
CN211 (Fan motor)
CN112 (Indoor coil thermistor)
CN1U1 (Horizontal vane motor)
CN151 (Vertical vane motor)
(4) Unhook the catches of the electrical box, and pull out the |
|
electrical box. (See Photo 4) | Be sure to assemble the |
| |
| the correct position |
4.Removing the nozzle assembly
(1)Remove the panel (refer to 1.) and the corner box.
(2)Remove the conduit cover, and then the indoor/outdoor connecting wire. (See Photo 2)
(3)Remove the sensor holder and the electrical cover. (See Photo 3.)
(4)Disconnect the following connectors on the electronic con- trol P.C. board;
| CN1U1 (Horizontal vane motor) |
|
|
|
|
|
| CN151 (Vertical vane motor) |
|
|
|
|
|
(5) Remove the power monitor receiver P.C. board holder and |
|
|
|
|
| |
| the holder. (See Photo 4) |
|
|
|
|
|
(6) Pull out the drain hose from the nozzle assembly and |
|
|
|
|
| |
| remove the nozzle assembly. | Photo 6 |
|
| ||
5. Removing the vertical vane motor unit |
|
| ||||
|
|
|
|
| ||
|
| Screws of the vertical vane motor unit cover |
| |||
(1) | Remove the nozzle assembly. (Refer to 4.) |
|
|
| ||
|
|
|
|
| ||
(2) | Remove the crank of the vertical vane motor unit from the |
|
|
|
|
|
| arm of the vertical vane. |
|
|
|
|
|
(3) | Remove the screw of the vertical vane motor unit, and pull |
|
|
|
|
|
| the vertical vane motor unit. |
|
|
|
|
|
(4) | Remove the screws of the vertical vane motor unit cover. |
|
|
|
|
|
(5) | Remove the crank of the vertical vane motor unit from the |
|
|
|
|
|
| shaft of the vane motor. |
|
|
|
|
|
( ) Only the crank of the left side vertical vane motor unit. (See |
|
|
|
|
| |
| Crank of the vertical | Screw of the vertical | ||||
| Photo 6) |
| ||||
(6) | Remove the vertical vane motor from the vertical vane |
| vane motor unit | vane motor unit | ||
| motor unit. |
|
|
|
|
|
(7) | Disconnect the connector of vertical vane motor from the | Photo 7 |
|
| ||
| vertical vane motor. |
|
| |||
|
|
|
| Screws of the vertical vane motor unit cover |
Screw of the vertical | Crank of the vertical |
vane motor unit | vane motor unit |
38